Operating Elements On The Subwoofer - Teufel Concept C 100 Technical Specifications And Operating Instructions

Operating elements on the subwoofer

Serial No.
Y
Power
Warning: To reduce the risk of fire or electrical shock
U
On
I
Off
AC 220-240 V~50/60 Hz
150 Watts
Fuse T 2 AL/250 V
Subwoofer power amplifier Concept C 100
Q Aux In (R / L)
You can connect an audio source appliance (PC, Mac,
CD player, etc) to the Concept C 100 / 200 here. You will
also need a stereo cinch cable (possibly with adapter).
W Remote Control
Connect the cable provided for the table remo-
te control here. Please note that this cable can
only be connected one way round (with the arrow
pointing to the right). Connect the cable carefully
to avoid damaging it.
E Mic Out
(Concept C 100 only)
Using a 3.5mm jack cable, connect the Concept C
100 Subwoofer to the "Line In" or "Mic In" input
of your PC or Mac so that you can use the micro-
phone input ("MIC") on the table remote control
(see page 11, U).
R USB
(Concept C 200 only)
Connect the Concept C 200 to your PC or Mac
here using the USB cable (connector type "B" to
"A"). We recommend this type of connection for
the Concept C 200 because the microphone input
("MIC") at the table remote control can only be
used if the Concept C 200 is connected to the PC
via USB.
Aux In
Q
R L
Remote Control
W
Mic Out
E
Model
CC 100 SW
+ –
Right
T
Left
Speaker Out
U
do not expose this appliance to rain or moisture.
Caution
Risk of electric shock!
I
Do not open!
Attention
Risque de choc electric! Ne pas ouvrir!
Subwoofer power amplifier Concept C 200
T Speaker Output (Right / Left)
Connect the speaker cable from the two satellites
here. Please observe the plus and minus polarity
and the set-up of the satellite speakers (right =
right satellite, left = left satellite).
Y Power (On / Off)
When set to "Off " , the subwoofer is switched off,
and when set to "On" it is switched on.
U Mains cable
Connect the mains power cable supplied here, in
order to connect the Concept C 100 / 200 to the
power supply.
I Fuse
gram opposite.
Only change the fuse if the subwoofer is com-
pletely disconnected from the mains power
supply, otherwise fatal injury could result!
Remote Control
Model
T
Serial No.
Y
Warning: To reduce the risk of fire or electrical shock
Power
do not expose this appliance to rain or moisture.
On
Risk of electric shock!
Off
Risque de choc electric! Ne pas ouvrir!
AC 220-240 V~50/60 Hz
300 Watts
Fuse T 3.15 AL/250 V
You can change the
mains fuse here if re-
quired – it should only
be replaced with one
of the same type and
amperage. Please use
a suitable screwdriver
for changing the fuse,
as shown in the dia-
Explanation of symbols
Aux In
Q
R L
The arrow-headed lightning
symbol in an equilateral triangle
W
indicates the presence of a
dangerous non-insulated elec-
trical voltage within the system
R
USB
housing and therefore a risk of
electrical shock..
CC 200 SW
+ –
Right
Left
The exclamation mark in an
Speaker Out
equilateral triangle, as affixed
to the appliance, is to make
the user aware of important
operating and maintenance
instructions.
Caution
Do not open!
Attention
This product complies with
European Community guidelines
89/336 EEC and 72/23 EEC
The dustbin symbol printed
on our products' type plates
and amplifiers states that
Lautsprecher Teufel guarantees
proper disposal of these speakers
and subwoofers in line with the
Electrical and Electronic Appli-
ance Act.
This product corresponds to
standards DIN EN 61140 (VDE
0140-1) and IEC 60417 of safety
class II and does not require
a safety plug, just the plug
included (2-pole). The casing has
reinforced or double insulation
against electric shock.
· Concept C 100 / 200 11