Controls And Connectors; Front Panel - Yamaha EXi8 Owner's Manual

Controls and Connectors

Front Panel

EXi8
EXo8
q [INPUT PEAK] indicators 1–8 (EXi8)
These indicators will light red when the input level of the
corresponding INPUT channel is -3 dBFS or higher.
w [INPUT SIGNAL] indicators 1–8 (EXi8)
These indicators will light green when the input level of the
corresponding INPUT channel is -40 dBFS or higher.
When a problem or abnormality occurs in the unit, the indi-
cator that corresponds to the appropriate alert number will
flash in green together with the flashing front panel
[ALERT] indicator.
e [OUTPUT SIGNAL] indicators 1–8 (EXo8)
These indicators will light green when the output level of the
corresponding OUTPUT channel is -40 dBFS or higher.
When a problem or abnormality occurs in the unit, the indi-
cator that corresponds to the appropriate alert number will
flash in green together with the flashing front panel
[ALERT] indicator.
r [ALERT] indicator
When a problem or abnormality occurs in the unit, this indi-
cator will flash in red and at the same time the [INPUT SIG-
NAL] or [OUTPUT SIGNAL] indicator that corresponds to
the alert number will flash in green. For explanations of the
alerts, refer to the "Alert list" on page 13.
Alert number
Example: When a problem related to alert number "3" occurs
t [POWER] indicator
This indicator will light when this device is powered-on.
y [NETWORK] indicator
This indicator will light green if a link is established with an
external device via the rear panel NETWORK connector
(page 9). It will flash while data is being sent or received.
q w r t
e r t
u [YDIF] indicator
This indicator will light green if the rear panel [YDIF IN]
connector (page 9) is correctly connected to the [YDIF
OUT] connector of another device.
i
Power switch
This is the power switch. The power is on if the switch is in
the position. The power is off if the switch is in the
position.
NOTE
• Do not cycle the power switch in rapid succession. Wait at
least 6 seconds before turning the power switch on after it
has been turned off. Failing to observe this precaution
may cause malfunctions.
• Even when the power switch is turned off, a small amount
of current is flowing through the unit. If you plan not to use
the unit for a long period of time, remove the power cable
from the AC outlet.
y u i
y u i
EXi8/EXo8 Owner's Manual
7