Install Intel® I/O Expansion Module (Optional); Install Intel® Esrt2 Raid Axxraksw5 Upgrade Key (Optional); Install Intel® Remote Management Module 4 (Optional) - Intel R1000RP Series Quick Installation

General Installation Process
15
Install Intel® I/O Expansion Module
(optional)
A
Squeeze the sides of the filler panel to
disengage it from the server system
back panel and remove it.
B
Position the module over the server
board, fit the front of the module into
the back panel slot.
C
Attach the module to the server
board connector.
D
Secure the module with the three
screws as shown.
Note: If included, remember to install the EMI shield.
17
Install Intel® Remote Management Module 4 (optional)
Installing the Intel® RMM4 Lite
A
Locate the RMM4 Lite
connector close to the
Riser Slot.
Carefully pick up the
Intel RMM4 Lite
®
module, match the
alignment pin of the
module and the
connector on server
board. Press to install.
C
Connect the cable to the RMM4 NIC connector to the RMM4 NIC connector on your server board.
D
Mount the NIC module to the rear panel of the chassis and secure the bracket with two screws.
E
Connect the cable to the cable connector on the Intel
Caution: Care should be used when attaching or removing this cable. Mishandling the cable could cause damage.
D
A
B
C
I/O Connector
A
Caution: Carefully remove the knock out with screwdriver, directly removing it with finger has potential risk.
Latch
®
Dedicated Server Management NIC module.
9
16
Install Intel® ESRT2 RAID
AXXRAKSW5
Upgrade Key
(optional)
Locate the white 4-pin key,
carefully pick up the Intel ® RAID
C600 Upgrade Key. Match the
key and connector orientation
and press down to install.
AF006070
Installing the Intel® RMM4 NIC
A
Attach the metal fastening bracket to Intel
Server Management NIC module and secure the bracket
with two screws.
B
Remove the alternate RMM4 knock out by pressing the
knock out from inside the chassis.
E
®
Dedicated
B
Chassis
Back
Opening
Filler
D
C
Latch