Summary of Contents for SportDOG Upland Hunter 1875
Page 1
OPERATING GUIDE PLEASE READ THIS ENTIRE GUIDE BEFORE BEGINNING...
Page 2
IMPORTANT SAFETY INFORMATION Explanation of Attention Words and Symbols used in this guide ____________________________________________________________________ This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Page 3
• If the condition persists beyond 48 hours, see your veterinarian. For additional information on bed sores and pressure necrosis, please visit the FAQ section for remote trainers at www.sportdog.com. These steps will help keep your dog safe and comfortable. Millions of dogs are comfortable while they wear stainless steel contacts.
To get the most protection out of your warranty, please register your product within 30 days at www.sportdog.com. By registering, and keeping your receipt you will enjoy the product’s full warranty and should you ever need to call the Customer Care Center, we will be able to help you faster. Most importantly, SportDOG ™...
Collar Receiver to deliver a harmless stimulation. With proper training, a dog will learn to associate this signal with a command. Like all SportDOG products, this model features adjustable stimulation levels so you can tailor the stimulation level to your dog’s temperament, eliminating the risk of over-correction.
KEY DEFINITIONS REMOTE TRANSMITTER REMOTE TRANSMITTER: Transmits the radio signal to the Collar Receiver and Remote Beeper. It is waterproof and TRANSMITTER can be submerged in water to a depth of 25 feet. ANTENNA INTENSITY DIAL: Provides multiple levels/types of TOGGLE stimulation so you can match the correction to your dog’s SWITCH...
Page 7
BEEPER: The point at which the sound is produced. CHARGING JACK: For connecting the charger. Although the Remote Beeper is waterproof without it, keep the cover in place when not charging to keep debris out of the opening. WWW.SPORTDOG.COM...
PREPARE THE REMOTE TRANSMITTER CHARGE THE REMOTE TRANSMITTER 1. Lift the rubber cover protecting the Charging Jack. 2. Connect one of the charger connectors to the Charging Jack. 3. Plug the charger into a standard CHARGER 120/240-volt AC wall outlet. CONNECTOR PLACED IN THE REMOTE 4.
Press and release the On/Off Button. The Receiver Indicator Light comes on solid (red) and the Collar Receiver beeps continuously for 2 seconds. To extend the life between charging cycles, turn the Collar Receiver off when it is not in use. WWW.SPORTDOG.COM...
Page 10
RECEIVER INDICATOR LIGHT OPERATIONAL LIGHT LIGHT FUNCTION BATTERY SPEAKER VIBRATION MODE COLOR STATUS FUNCTION Unit is turned on via Green Light is solid in color Good Beeps On/Off Button during beep sequence 1-3 times depending on stimulation range setting Unit is turned on via Light is solid in color (2 is the default On/Off Button...
Unit is on Light fl ashes every 3 seconds Unit is turned on via On/Off Button Green Light is solid in color during beep sequence Unit is turned off via On/Off Button Light is solid in color during beep sequence WWW.SPORTDOG.COM...
• If the condition persists beyond 48 hours, see your veterinarian. For additional information on bed sores and pressure necrosis, please visit the FAQ section for remote trainers at www.sportdog.com. These steps will help keep your dog safe and comfortable. Millions of dogs are comfortable while they wear stainless steel contacts.
Contact Points, switch to the longer Contact Points included in your system or change the stimulation range (see page 14). If after completing all of these steps your dog still does not indicate he is feeling the stimulation, please contact Customer Care Center at 1-800-732-0144. WWW.SPORTDOG.COM...
CHANGE STIMULATION RANGES The UplandHunter ® 1875 Collar Receiver comes with 3 stimulation ranges (low, medium and high). There are 7 stimulation levels within each range, with 1 being the lowest and 7 being the highest. The default range setting is 2 or medium. To change the range of stimulation, follow these steps: 1.
Mode 3, in both the Toggle Switch up and down position, provides more “increments” to choose from – a total of 14 levels of stimulation. For example, in mode 3 with the Intensity Dial set at 2, the lower button provides level 3 of 14 and the upper button provides level 4 of 14. WWW.SPORTDOG.COM...
Page 16
TOGGLE SWITCH IN THE UP POSITION MODE UPPER LOWER LEFT-SIDE RIGHT-SIDE TOGGLE BUTTON BUTTON BUTTON BUTTON SWITCH FUNCTION FUNCTION FUNCTION FUNCTION FUNCTION FUNCTION HIGH HIGH Call/Locate Up: Dog 1 Tone Continuous Momentary Mode – Mode Down: Dog 2 stimulation* (nick) single tone** stimulation* HIGH...
Page 17
+2 Intensity Mode – Mode Down: Dog 2 stimulation* Continuous single tone** stimulation* *Stimulation levels set by intensity dial **Call/Locate Mode turns off Run Mode ***To enable Run Mode, press and hold the corresponding Locate Button for 3 seconds WWW.SPORTDOG.COM...
MATCH THE COLLAR RECEIVER, REMOTE BEEPER AND REMOTE TRANSMITTER To reset the Collar Receiver/Remote Beeper to work with a new Remote Transmitter or to reprogram a new Collar Receiver/Remote Beeper to work with your existing Remote Transmitter: A. Turn the Collar Receiver/Remote Beeper off. B.
3 Beeps (10 second) Beeps every 10 seconds when dog is running/Beeps once per second when dog is on point 6. Release the button after the corresponding number of beeps matches your desired run mode. WWW.SPORTDOG.COM...
SportDOG ™ Collar Receivers/Remote Beepers can be set to respond to either the up or down toggle switch position. A SportDOG Add-A-Dog ® Collar Receiver/Remote Beeper must be purchased to train/ locate a second dog in two-dog mode. Please refer to back cover for the compatible Add-A-Dog Collar Receiver/Remote Beeper for this system.
ID change is complete. 2. Do not press any buttons and wait until the green indicator light turns off. 3. You will now need to match the Collar Receiver and Remote Beeper to the Remote Transmitter (see Step 7 on page 18). WWW.SPORTDOG.COM...
ACCESSORIES To purchase additional accessories for your SportDOG Brand ® UplandHunter ® 1875, contact the Customer Care Center at 1-800-732-0144 or visit our website at www.sportdog.com to locate a retailer near you. Component Part Number ⁄ ” Grey Collar Strap SAC00-13864 ⁄...
Be sure the extra collar does not interfere with the Contact Points. Can I program my UplandHunter 1875 to The UplandHunter 1875 will work with SD-1825, SD-1825CAMO and work with my other SportDOG Brand ® SD-2525 systems. systems?
Page 24
Can I use the Remote Beeper by itself? Yes, the Remote Beeper can be used independently without the Collar Receiver. However, it is recommended to have a counter weight, like the Collar Receiver, in order to keep the Remote Beeper on top of the dog’s neck.
The answers to these questions should help you solve any problem you have with this system. If they do not, please contact the Customer Care Center at 1-800-732-0144 or visit our website at www.sportdog.com. My dog is not responding when I press •...
My Remote Beeper cannot be reset. • Verify the Remote Beeper has been turned on and the Indicator Light is fl ashing. Refer to “Turning the Remote Beeper On and Off”. • Refer to “Match the Remote Beeper.” Note: Only the Locate button can program/reset the Remote Beeper.
BATTERY DISPOSAL See important safety information on page 2 related to the battery. This system operates on three Li-Ion battery packs (240mAh capacity for the Collar Receiver, 550mAh capacity for the Remote Transmitter and 400mAh for the Remote Beeper). Only replace with battery received from calling the Customer Care Center at 1-800-732-0144.
Need help?
Do you have a question about the Upland Hunter 1875 and is the answer not in the manual?
Questions and answers