Related Manuals for Phonak TX-300V
Summary of Contents for Phonak TX-300V
- Page 1 User’s Manual TX-300V Studio Transmitter Phonak Communications AG Laenggasse 17 3280 Murten Switzerland T +41 (0) 26 672 96 72 F +41 (0) 26 672 96 77 info@phonakcom.ch www.phonakcom.ch...
- Page 2 • Antenna Mounting Assembly • 50 Ohm Coaxial Cable (7.6m) Rack Mount Kit (part number 116-1940, see page 14) Phonak and the Phonak Logo are registered trademarks of Phonak Communications AG. ™ TX-300V_2006_01_20 © 2006 Phonak Communications AG. All Rights Reserved.
-
Page 3: Table Of Contents
Table of Contents Specifications............4 Block Diagram . -
Page 4: Specifications
Unit Weight with Power Supply 2.0 kg (4.4 lbs) Shipping Weight 2 kg (5.0 lbs) Rack Mounting ½ rack unit, optional rack mount not included. Order Phonak part number 116-1940 Temperature - Operation Environmental Temperature - Storage Humidity 0 to 95% relative humidity, non-condensing... -
Page 5: Block Diagram
TX-300V Block Diagram POWER RS-232 DB-9 Connector Programming 3.5MM CHANNELSELECT MONITOR Universal 115/230VAC Power Supply 50/60 Hz (included) 12VDC, 1.3A Power Supply Volume Down CPU Module Phonak LCD Display MIX Level VU Meter Compression Ratio (internal adjustment) Remote Antenna (included) -
Page 6: Quick Reference
Quick Reference TX-300V Front Panel: Controls & Displays Indicates Process Mode is active Indicates audio input LCD: Shows Adjust audio input levels level of Input 1 and which channel of Input 1 and Input 2 Shows mixed Input 2 is selected here. -
Page 7: Setup Instructions
Mount in Rack (if necessary) If rack mounting the unit, install the optional rack mount kit (part 116-1940) according to the instructions included with the kit, then install the TX-300V in the Back of TX-300V with XLR connected to Line Input 1 rack. - Page 8 TX-300V Setup Instructions continued Antenna Installation Your TX-300V Studio Transmitter Set includes a remote antenna that features two adjustable-length radials. Extending these radials to the correct length is extremely important for the system to achieve maximum transmission range. Use the following process to determine how long to set your antenna radial...
-
Page 9: Operating Instructions
Press Test Tone button here Your TX-300V has been shipped to you with process mode enabled. To enable or disable process mode hold TX-300V Audio Control the channel select “Down” button for 8 seconds while the unit is on. -
Page 10: Rf Reception Maximization Strategies
5. Place the transmitting antenna as high as possible. 6. Orient the transmitting antenna vertically. 7. Position the RF Power switch on the back of the TX-300V to full RF Power, unless lower power is necessary (see page 7). 8. Extend radials to the correct length for selected frequencies (see page 8). -
Page 11: Troubleshooting
Make sure you have properly grounded the audio source to the TX-300V. Check the connections from the audio source to the TX-300V. If you can, try to use a balanced audio source - this will reduce the chance of creating hum. Connect a ground wire from the TX-300V to ground and/or to the ground of the source audio. -
Page 12: Compliance Notice
422, EN 300 454, EN 301 489-1/-9 and FCC 47 C.F.R. Part 74, including all necessary annexes. Please check with your local Phonak distributor, if you need a license from your local regulatory agency to operate the system. This transmitter may only be used to provide auditory assistance to persons in studio, stage and entertainment settings and persons with hearing disabilities. -
Page 13: Warranty
Warranty Phonak offers you a comprehensive global warranty which becomes effective on the date of purchase. Please ask your local Phonak distributor about the details and duration. This warranty covers any repairs due to defects in material and/or workmanship. The warranty does not cover damage from improper handling or care, exposure to chemicals, immersion in water or undue stress. -
Page 14: Optional Accessories
Rack Mount Kit 116-1940 Rack Mounting Kit Includes components for single and dual rack configuration and a security cover... - Page 16 Phonak Communications AG Laenggasse 17 3280 Murten Switzerland T +41 (0) 26 672 96 72 F +41 (0) 26 672 96 77 info@phonakcom.ch www.phonakcom.ch...
Need help?
Do you have a question about the TX-300V and is the answer not in the manual?
Questions and answers