Related Manuals for Mobeye CM2400
Summary of Contents for Mobeye CM2400
- Page 1 USER MANUAL ® Mobeye Smoke Detector CM2400 ® Mobeye Heat Detector CM2400H SW version 1.n...
- Page 2 • Please refer to the manual of the EI Electronics detector for the complete safety guidelines. Use in accordance with the regulation The use of the Mobeye GSM module in accordance with the regulation is sending SMS text messages and making telephone calls after an alarm situation. Other usages are not permitted.
-
Page 3: Table Of Contents
CONTENT General description Getting started Place a SIM card Place the batteries Enter the program mode Program at least one telephone number Mount the GSM module housing to the ceiling Fix the cover to the GSM module housing Connect the EI detector and close the cover Perform a test Several detectors in a wireless network Use of external power supply... -
Page 4: General Description
CM2400(H) sends an alarm SMS text message and calls to the phone numbers as programmed by the user. - In case the batteries need to be replaced, the Mobeye CM2400(H) sends a ‘battery low’ SMS text message to the administrator. -
Page 5: Getting Started
2. GETTING STARTED To get started with the Mobeye CM2400(H) at least the following steps need to be taken in following order: 1. Place a SIM card (with PIN code 0000 or without PIN code) 2. Place the batteries 3. Enter the program mode 4. -
Page 6: Mount The Gsm Module Housing To The Ceiling
In the EI detector a red light will flash regularly. 2.8 PERFORM A TEST After the previous steps, the Mobeye CM2400(H) is in use. It is armed (switched on) automatically. The green LED on the GSM module blinks once in 3 seconds, which can only be seen when opening the back cover of the EI detector. -
Page 7: Several Detectors In A Wireless Network
3. SEVERAL DETECTORS IN A WIRELESS NETWORK Although the Mobeye CM2400(H) can run as stand-alone unit, it is also possible to form a wireless network with several EI detectors. For this purpose each EI Electronics detectors needs to be equipped with an RF module. -
Page 8: Use Of External Power Supply
4. USE OF EXTERNAL POWER SUPPLY Although the Mobeye CM2400(H) is designed to run on batteries, it is possible to use an external power supply. In this mode the module is always in connection with the GSM network and therefore always in program mode. -
Page 9: Extended Options
The unit returns to the low power operational mode. In case the unit is connected to an external power supply, the CM2400(H) has network connection all the time and the unit is in program mode all the time. -
Page 10: Possible General Settings
This paragraph describes the general settings for the CM2400(H). 5.4.1 Phone numbers The Mobeye CM2400(H) is able to send alarm messages up to 5 phone numbers. The first telephone number (TEL1) belongs to the administrator. Only this number receives all system messages. The other phone numbers (including the administrator) only get the alarm messages. -
Page 11: List Of Sms Commands For Configuration
(be aware of the space behind 1111) 5.6 RESET OF SYSTEM To reset the Mobeye CM2400(H) to its factory settings: Open the back cover of the GSM module, using the reverse order as explained in chapter 2 Remove the batteries Press the red button while entering the batteries. -
Page 12: Request List Of The Settings And Status
6.2 LIST OF GENERAL SETTINGS The general settings of the Mobeye CM2400(H) can be requested by sending an SMS with the content <CODE> SET? Upon sending this request, the Mobeye CM2400(H) returns the list of programmed settings to the originator of the request. -
Page 13: Technical Messages And Status Feedback
7. TECHNICAL MESSAGES AND STATUS FEEDBACK Technical messages In case of technical issues the administrator receives an SMS message. Possible technical messages are: Message Reason Low batteries, external power supply Power is available, batteries need to be replaced No external power supply, batteries No external power supply, batteries are capable to take over operation in low power mode Low batteries, no external power... - Page 14 Publisher. Reprinting, even in summary, is prohibited. This user manual meets the technical requirements at the moment of printing. Changes in technology and equipment are reserved. © Copyright 2013 by Mobeye, version CM2400(H)EN130331...
-
Page 15: Declaration Of Conformity
Directive 1995/5/EC R&TTE (Radio & Telecommunications Terminal Equipment) The conformity with the essential requirements of 1995/5/EC has been verified against: ETSI EN 301 489-1 V1.5.1 ETSI EN 301 489-7 V1.2.1 ETSI EN 301 511 V9.0.2 CENELEC EN 60950:2001 Mobeye B.V., Poeldonkweg 5, 5216 JX ’s-Hertogenbosch, The Netherlands...