Troubleshooting - INSTEON Mini Remote 2342-242 Owner's Manual

LED
Setup Button
On/Off Switch
Beeper
Battery Charging LED
RF Range
RF Frequency
Retains all settings without power
Mechanical
Color
Plastic
Button Configurations
Dimensions
Weight (w/battery)
Button Style
Optional Hardware
Operating Environment
Electrical
Battery type
Battery life (between charges)
Battery Re-charging cycles
Recharging jack
Recharging time
Sends Low Battery Warning

Troubleshooting

Problem
Mini Remote won't add a
scene responder
Page 13 of 16
Red Blink for ~3 Seconds
Always used for setup, default On during use
Yes
Yes
Yes, configurable
Yes, Embedded (shines red through case during charge)
50' Line-of-Sight
915MHz (US)
869MHz (EU)
921MHz (AUS/NZ)
Yes, all saved in Non-volatile EEPROM
White
UV Stabilized ABS
1 Scene (standard), 2 Scene (optional button kit)
2.6" H x 1.3" W x 0.39" D
1 Oz.
Plastic Paddles over Contact Switches
Wall Mount
Tabletop Stand
Visor Clip
Indoors, 32°F to 104°F, up to 85% relative humidity
3.7 VDC Lithium Polymer, Rechargeable, non-replaceable
> 3 months under standard usage
> 500 recharging cycles
Standard, Micro-USB, 5VDC
~1 hour
Yes
Possible Cause
Mini Remote may be out of range of
nearest dual-band INSTEON device
(hopper)
The INSTEON signal may not be
getting to the "vicinity" of responder
Scene Acknowledge Missing
Solution
Try moving an access point or other dual-band
plug-in module closer to Mini Remote
Make sure phases are bridged, add additional
INSTEON devices and/or move around existing
INSTEON devices
2342-242/2444A3, 2342-442, 2342-542 Rev: 1/21/2014 7:24 AM