OPERATING INSTRUCTIONS (continued)
D / N
i +
I / II
A/B button
A / B
MENU
P+
-
OK
P-
D VD
1
2
4
5
7
8
0
2 Pictures (Split)
Input terminal
PAL
Sub
Main
SECAM
PAL, SECAM
AV1
~AV4
NTSC3.58/4.43
576i, 576p
480i, 480p
AV1
1080i/50
AV2
1080i/60
720p/60
RGB1
STB
RGB2
Component
NOTE
• Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not
change to power save mode.
• Please be careful since image retention will occur if display is left in a MULTI PICTURE display state for a long period of time.
Input Signal Screen Display
The input signal status can be displayed on the screen
by pressing the RECALL button of the remote control.
• The display will go out in approximately 6 seconds.
RECALL button
PinP button
2- 4- 12
SELECT button
+
FREEZE
ZOOM
3
6
9
AV1~AV4
AV1, AV2
NTSC3.58
576i
480i
1080i/50 1080i/60 720p/60
NTSC4.43
576p
480p
Displaying MULTI PICTURE
If the PinP button on the remote control is pressed MULTI
PICTURE will display.
Activating the P-in-P mode from the RGB input screen
Pressing the PinP button one time will display 2 pictures.
• This mode can be available from RGB1(DVI-PC) and RGB2(RGB)
input.
• The speaker icon can be shifted left and right by pressing the A/B
button; the audio of the video will be output from the side on which
the speaker icon is located.
• The sub-screen position can be
selected up and down by pressing
SELECT buttons.
• The sub-screen can be selected with
the AV1, AV2, AV3, and AV4 buttons
from the status that the speaker icon
✱
appears on the left side of AV
shown in the diagram to the right.
• Pressing the PinP button again or the RETURN button will cancel
the 2 pictures display.
• "Frequency Mode" in the Setup Menu should be set to Movie when
sub-screen is the component signal of 1080i/50 or 1080i/60.
AV1: Displays the VIDEO input signal of the sub-screen.
Activating the Split mode from the video input screen
Pressing the PinP button one
time will display 2 pictures.
• The speaker icon can be shifted left
and right by pressing the A/B
button; the audio of the video will be
output from the side on which the
speaker icon is located.
• The same video input mode cannot
be selected for both screens at the
same time.
• Pressing the PinP button again or the RETURN button will cancel
the 2 pictures display.
• When the Video input is set to RGB Video, this Split mode is not possible.
• Refer to the table for 2 pictures (Split) mode.
RGB1
RGB2
STB Component
(
: Available)
VIDEO
Off-timer
-- -- Min.
OFF
-- -- : -- --
On-timer
ON
RGB2
AV1
(Sub-
screen)
as
AV1
AV2
Main
Sub
Input mode
AV1
Signal mode
Composite
31