Page 1
Headphone Distribution System and Personal Headphone Mixer MODELS HDS-6, HR-6 Furman Sound, Inc. 1997 S. McDowell Blvd. Petaluma, CA 94954-6919 Phone (707) 763-1010, Fax (707) 763-1310 e-mail: info@furmansound.com Owner’s Manual Web: http://www.furmansound.com Made in China 2-9815 2002 Furman Sound, Inc.
Page 2
The HDS-6 typically connects to a mixing console and provides both the interface and power to drive a chain of HR-6 mixing stations. Since the HDS-6 provides signal, power and ground to the HR-6 remote mixers, you don’t have to worry about locating your HR-6 remote mixing stations near an AC power outlet.
Page 3
But standard ¼” phone-plug cables will work fine too. Just connect the direct-out of a mixer channel strip or buss to an input of the HDS-6, and connect any stereo output of the mixer to the stereo inputs on the HDS-6. Remember, you can...
Page 4
HDS-6/HR-6 HEADPHONE DISTRIBUTION SYSTEM HDS-6 Controls this red LED doesn’t glow at all, your HDS-6 gain is set too low. What you want The HDS-6 provides several simple controls and indicators that make it to see is the LED glowing occasionally, on the loudest peaks only.
Page 5
This warranty applies only to the original owner and is not transferable. arriving at the HR-6 from your console through the HDS-6. Remember: If you use the Also, it does not apply to repairs done by other than the Furman factory or HDS-6’s Left-Right inputs to accommodate two or more console channels or busses...
Page 6
Headphone Passive Remote Box HDS-6 Headphone Distribution System HR-6 Personal Headphone Mixer for use with HDS-6 HR-6SPLT Star Connection Breakout Box for use with HDS-6 HDS-16 Headphone/Audio Distribution System HRM-16 Personal Headphone Mixer for use with HDS-16 PB-48 48-Point Patch Bay with TRS Connectors...
Need help?
Do you have a question about the HDS-6 and is the answer not in the manual?
Questions and answers