How To Change A Ribbon - Amano 4700 Series User Manual

How To Change A Ribbon

(Refer to Fig. 6 & 7)
•
In case the print color becomes too light, or the ribbon is cut or
crumpled too much, please replace the ribbon with a new one.
•
First check whether the ribbon reverse turn lever [6] (see Figure
6) is inclined to the inner side of the machine. Incase the lever is
inclined to the front, push it in the direction of the inner side.
•
Wind the whole ribbon onto the ribbon spool [7] located in the
front of the machine, then remove the ribbon with the spool from
the machine.
•
Install a new ribbon with spool [7] on the machine. Then wind the
ribbon on the ribbon spool [8] through the outside ribbon guide
shaft [9], and fix with the ribbon fixer [10].
•
Wind the ribbon on the ribbon spool [8] until the slack ribbon
disappears, and pull the ribbon reverse lever [6] front wards.
4700/4800 Series Time Stamp Operation Manual
Figure 6.
5