Panasonic TH-50PB2U Operating Instructions Manual page 26

Electronic pen, electronic pen adapter, charger, electronic pen, interactive plasma display
Hide thumbs Also See for TH-50PB2U:
Table of Contents

Advertisement

■ To remove the rechargeable battery
Completely exhaust the battery in the following procedure before disassembling.
Remote erase button
How to disassemble
Remove the rechargeable battery in the steps
26
Remote draw button
Power button
Do not disassemble this product except when disposing of it.
The following gures are intended to explain
how to dispose of the product, not for describing how to repair.
The product cannot be repaired once it has been disassembled.
Cutout
Cutout
While the power of the electronic pen is off, press and hold
the "remote draw button" and press the power button,
release both the buttons, and press and hold the "remote
erase button" 5 seconds.
(Keep pressing until the power button starts blinking
orange.)
Check that the power button repeats 5 times of orange
blinks.
If it does not blink orange, press and hold the power button to
turn the power off (light off) and perform the procedure again.
Leave the electronic pen untouched while the power button
repeats blinking
When the battery is exhausted, the power button stops blinking
and you can disassemble the electronic pen.
It may take approximately 5 hours at most to exhaust the
battery.
to
Turn and remove the pen tip cover and eraser tip cover
Remove the pen tip and eraser tip
Insert the slotted screwdriver into the cutout to open the
main body

Advertisement

Table of Contents
loading

This manual is also suitable for:

Th-65pb2uDkb-dp13N0hzzy000003Ssr-rfnano

Table of Contents