E-Trigger Battery Installation Or Replacement; Operation; Changing The Firing Mode - Tippmann Bravo One ELITE Owner's Manual

2. E-Trigger Battery Installation or Replacement

a. Remove two screws (49) and the left grip (50) shown in Figure 5.
b. Carefully remove the old battery out of receiver cutout bringing non-connected
end out first. As you remove the battery from the receiver, do not pull on the wires.
You might pull the wires off of the internal Electronics
Assembly.
c. Carefully remove the old battery from the battery
connector.
d. Attach a new 9 volt battery to the battery connector,
using the correct polarity of the battery. Be sure
wires lay flat inside the cutout area of receiver
(as shown in Figure 16 on page 19). Carefully tilt
and insert the new battery, connector end first, into the
receiver as shown in Figure 6.
e. Reinstall left receiver grip with twp grip screws. Battery
installation is complete.
: The E-Trigger has a low battery indicator. The "Ready
NOTE
To Fire" solid green LED light turns to a red LED light when the
battery is low and needs to be replaced.

3. Operation

To Turn the E-Trigger for normal operation (Ready To Fire):
ON
a. Without holding the trigger, use a small object like the
included allen wrench to press and hold the power button
for about 5 seconds until the LED light comes on green.
b. When you see the green light, release the power button.
c. Your marker is now ready for normal operation in the
Semi-Auto Firing Mode (1 pull of the trigger fires 1 time).
This is the Factory Default Firing Mode Setting.
: If pressing the power button failed to turn on the LED light,
NOTE
see
E-Trigger Troubleshooting
To turn the E-Trigger, press and hold the power button until the LED turns off, then
OFF
release the power button.
: The E-Trigger will shut off automatically after a prolonged period of inactivity.
NOTE

4. Changing the Firing Mode

Put the Trigger Safety in Safe mode (page 6) and install the Barrel Blocking Device (page 4).
The firing mode that you choose determines how the marker reacts to trigger pulls.The default
firing mode is Semi-Auto. To select a new firing mode, turn on the E-Trigger. Each press and
release of the power button advances the firing mode to the next firing mode in the menu (the
LED flashes 1, 2, 3 or 4 times to identify the firing mode you have selected).
(1 pull/release of the trigger fires 1 time.) The LED flashes
SEMI-AUTO
the marker fires in Semi-Auto mode.
Press and release the power button to choose the next firing mode
(once started, provides a 3 shot burst for each pull of the trigger). To fire in
TRIPLE FIRE
Triple Firing mode you must pull the trigger 2 single pulls within 1 second and the third trigger
pull fires a 3 shot burst at a rate of 12 paintballs per second (bps). Subsequent trigger pulls
within 1 second fire additional 3 shot bursts.
on page 12.
11
49
Figure 5: Remove Grip Screws
t B
oP of attery
Figure 6: Remove Battery
P
ower
B
utton
Figure 7: Power Button
and LED Location on
Front of Grip
time to indicate
one
E
N
G
L
I
S
50
H
Led