Connecting Wires To Terminals - Kenwood KRC-335 Instruction Manual

What-might seem to be a malfunction in your unit may
? The sound quality is poor or distorted.
just be the result of slight misoperation or miswiring.
(/ One of the speaker wrres IS being pinched by a screw in the car
Before calling service, first check the following table
SR Check the speaker wrrrng.
for possible problems.
/ The tape head IS dirty
0~ Clean the tape head
General
/ The speakers are not wired correctly
? The power does not turn ON.
L'-, Reconnect the speaker wires so that each output termrnal IS
/ The fuse has blown
connected to a drfferent speaker
1'3 After checking for short crrcurts rn the wares, replace the fuse wrth
? The Touch Sensor Tone doesn't sound.
one with the same rating
/ The preout lack IS being used
/ No ACC position on vehicle rgnltron
~7 The Touch Sensor Tone can't be output from the preout lack
c' Connect the same wrre to the rgnrtron as the battery wrre.
? Nothing happens when the buttons are pressed.
Tuner source
/ Thecomputer chip I" the unit IS not functronrng normally.
0 1 Press the reset button on the unit (page 4).
? There's a source you can't switch.
(/ There's no tape Inserted.
en Set the media you want to listen to If there's no media rn this
unit, you can't swhrch to each source.
/ The DISC changer Isn't connected.
? Radio reception is poor.
(/ The car antenna IS not extended.
~1 Pull the antenna out all the way
ti The antenna control wrre IS not connected.
0.1 Connect the wire correctly. refemng to the sectron on
<Connectrnq Wares to Terminals>.
r-y Connect the Disc changer If the DISC changer isn't connected to
It's Input termrnal, You can't switch to an external disc source
? The memory is erased when the ignition is turned OFF.
/ The battery wire has not been connected to the proper terminal.
DS~ Connect the wrre correctly. referrrng to the sectron on
<Connecting Wires to Termrnals>
ti The ignrtron and battery wire are rncorrectly connected.
~11 Connect the wrre correctly, referring to the section on
<Connectrng Wires to Termrnals>.
? No sound can be heard, or the volume is low.
/ The fader or balance settings are set all the way to one srde.
D* Center the fader and balance settings.
fl The Input/output wires or wrrrng harness are connected Incorrectly.
r* Reconnect the Input/output wares or the wtnng harness correctly.
See the sectron on "Connectrng_Wires to Termrnals".
/ The cassette tape IS bad
D* Try playing another cassette tape. If works fine. the frrst tape was
bad.
- 20 -