Clarke WIZ - MINI Operating And Maintenance Instructions Manual

Clarke WIZ - MINI Operating And Maintenance Instructions Manual

Advertisement

Quick Links

WIZ - MINI
AIR COMPRESSOR
0206
OPERATING & MAINTENANCE
INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WIZ - MINI and is the answer not in the manual?

Questions and answers

Summary of Contents for Clarke WIZ - MINI

  • Page 1 WIZ - MINI AIR COMPRESSOR 0206 OPERATING & MAINTENANCE INSTRUCTIONS...
  • Page 2: Table Of Contents

    Thank you for purchasing your new Clarke WIZ Mini Air Compressor, which is not intended for general outdoor use. If it is used outdoors, it must be protected for the elements at all times. Before attempting to operate the compressor, please read this instruction manual thoroughly and carefully follow all directions given.
  • Page 3: Safety Precautions

    NEVER discharge compressed air against the skin. Electrical or mechanical repairs should only be carried out by a qualified engineer. If problems occur, contact your Clarke dealer. Before carrying out any maintenance, ensure the compressor is disconnected from the mains supply DO NOT operate in wet or damp conditions.
  • Page 4: Electrical Connections

    We recommend that this machine is connected to the mains supply via a Residual Current Device (RCD) If in any doubt, DO NOT attempt any connections or repairs yourself. Consult a qualified electrician, your Clarke dealer, or CLARKE International Service Dep’t 020 8988 7400 or e-mail: Service@clarkeinternational corn...
  • Page 5: Operation

    OPERATION NOTE: This machine is designed for use with air bushes or other devices that require a low volume, low pressure air supply. Check that the mains voltage corresponds with that shown on the data label on the crankcase cover of the machine. Ensure that the ON/OFF switch (see fig.
  • Page 6: Fault Finding

    Noisy operation Cyl Head Screws too Back off all screws and tight. tighten equally.. .to 10 lbf ft Bearing Fault Consult your Clarke dealer Cyl Head Screws too Back off all screws and Compressor tight. tighten equally.. .to 10 lbf ft hums but does not work.
  • Page 7: Parts List And Diagram

    PARTS DIAGRAM...
  • Page 8 PARTS LIST No. Description Part No. No. Description Part No. Housing KLWIZ01 Air Valve KLWIZ33 Gasket KLWIZ02 Screw KLWIZ34 Armature KLWIZ03 Screw KLWIZ35 Front Body Cover KLWIZ04 Screw KLWIZ36 Bearing KLWIZ05 Air Valve Plate KLWIZ37 Air tank KLWIZ06 Air Valve KLWIZ38 Washer KLWIZ07...

Table of Contents