Black Widow REMOTE START SECURITY SYSTEM Owner's Manual page 3

CHIRP DELETE
For full time silent operation, the ARM/ DISARM
chirps can be permanently disabled.This feature must
be programmed during installation.
IGNITION LOCK*
The ignition locking feature allows the doors to
automatically lock when the ignition key is turned on,
and automatically unlock when the ignition key is
turned off. This feature may be disabled during
installation.
REMOTE PANIC
In the event of an emergency (PANIC) situation, the
system's siren can be triggered for 45 seconds to
attract attention.To activate the Panic Feature, press
transmitter button I for 3 seconds:
• The siren will chirp once.
• To exit Valet Mode:
• The siren will sound.
• The parking lights will flash.
Press button I to exit panic mode and rearm
the system. Press button 2 to exit panic mode
and disarm the system.The Panic Feature will
operate when the ignition is on.
EMERGENCY OVERRIDE
If the 'transmitter becomes lost or fails to
operate, the system can be disarmed by using
the emergency override feature.
To override the system:
1. Enter the vehicle.
Because the system is armed, the siren
will sound.
2.Turn on the ignition key.
3. Press the Valet switch for 5 seconds.
The siren will stop sounding.
Starter defeat bypassed.
VALET MODE
When the system is placed into the Valet Mode
the security system will be disabled. However, the
optional keyless entry and trunk release and
remote start features will still function if
installed.
NOTE: Remote Start feature maybe disabled
during valet mode
installation.
To enter the Valet Mode:
I . Be sure the system is disarmed.
2.Turn the ignition key on.
3. Press and hold the valet/ser vice mode
switch for 3 seconds.
• The LED will chirp once.
• The LED will turn on solid indicating
the system is in Valet Mode.
To exit the Valet Mode:
1. Turn the ignition key on.
2. Press and hold the valet/service mode
switch for 3 seconds.
• The LED will turn off.
• The Siren will chirp 2 times.
OPTIONAL TRUNK RELEASE
Press button 3 for approximately 2 seconds to open
the trunk.
OPTIONAL TRUNK DISARM
The trunk disarm feature allows the alarm to
disarm automatically whenever transmitter
button 3 is used to activate the optional trunk
release.This eliminates having to first disarm
the alarm before activating the trunk release.
NOTE: This feature must be programmed during
installation.
REMOTE SENSOR BYPASS
To arm the system and bypass the shock sensor, press
button I to arm, then within 2 seconds press button I
again.The siren will chirp 5 times and sensors will be
ignored until the
*
Optional Feature
3
if programmed during