Removing/Mounting The Hydrostatic Transmission - Husqvarna Rider ProFlex 18 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Removing/Mounting the Hydrostatic
Transmission
1. Jack up the machine in front of the rear
frame and remove the rear wheels.
2. Remove the transmission cover.
3. ProFlex 21
Clean, see "Working Methods" on page 82.
Loosen the hydraulic hoses from the
hydrostatic transmission.
4. Remove the nut (2), lift off the washer and
fan from the ingoing shaft.
5. Remove the oil tank and hose from the
hydrostatic transmission.
6. Remove the clutch control and its spring.
7. Loosen the idler's spring (1) and pull off the
drive belt.
8. Loosen the throttle control's link joint (2) (on
the underside) and remove the cable from
the underside of the shaft.
9. Loosen the throttle control's link joint (on the
top) from the hydrostatic transmission arm.
10. Loosen the brake cable's (3) spring and
nuts. Remove the cable from the brake arm.
44
English-
REPAIR INSTRUCTIONS
www.mymowerparts.com
Jacking up
Hydraulic hoses
Spring and fan
4
2
Steps 1-4
6012-035
8009-366
6012-036
1
3
8009-047