TA-N9000ES SERVICE MANUAL US Model Canadian Model AEP Model UK Model E Model Australian Model Chinese Model Photo: GOLD model SPECIFICATIONS 5 CHANNEL POWER AMPLIFIER MICROFILM...
DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ SONY PARTS WHOSE PART NUMBERS APPEAR AS DE FONCTIONNEMENT. NE REMPLACER CES COM- POSANTS QUE PAR DES PIÈCES SONY DONT LES SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB- LISHED BY SONY. NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
SECTION 1 SERVICING NOTES MODEL IDENTIFICATION SAFETY CHECK-OUT After correcting the original service problem, perform the follow- – Rear view – ing safety check before releasing the set to the customer: Check the antenna terminals, metal trim, “metallized” knobs, screws, and all other exposed metal parts for AC leakage. Check leakage as described below.
SECTION 3 DISASSEMBLY Note: Follow the disassembly procedure in the numerical order given. CASE 3 case 1 two screws (BV3 x 8B) 2 two flat head screws 2 two flat head screws FRONT PANEL SECTION 5 front panel section 2 four connectors 3 three screws (CN152, 153, 154, 155) 1 Unlock each claw of the saddle wire.
Page 6
BOTTOM PLATE, BACK PANEL SECTION 9 two screws 8 two screws (BV3 5 Unlock each claw of 6 connector the saddle wire. (CN809) 6 connector 7 two screws (CN808) 6 connector (CN812) 8 two screws (BV3 0 back panel section 8 two screws (BV3 6 seven connectors...
SECTION 4 ELECTRICAL ADJUSTMENTS DC BIAS CURRENT Adjustment (with no signal input) After replacing the power transistors, DC BIAS CURRENT ad- justments should be perfomed. Setting: SPEAKER IMPEDANCE switch (S801): 8 MIN (NORMAL USE) Procedure: Connecting Adjustment Reading on point part the tester MAIN BOARD...
TA-N9000ES 5-1. NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS • Waveform 1 IC901 @º (X-OUT) Note on Printed Wiring Board: Note on Schematic Diagram: • X : parts extracted from the component side. • All capacitors are in µF unless otherwise noted. pF: µµF •...
TA-N9000ES 5-3. SCHEMATIC DIAGRAM – MAIN Section (1/3) – (Page 15) (Page 15) (Page 15) (Page 15) (Page 15) (Page 21) (Page 21) (Page 17) (Page 15) The components identified by mark ! or dotted Les composants identifiés par une marque ! sont line with mark ! are critical for safety.
TA-N9000ES 5-4. SCHEMATIC DIAGRAM – MAIN Section (2/3) – (Page 14) (Page 17) (Page 13) (Page 17) (Page 14) (Page 14) (Page 14) (Page 14) (Page 17) The components identified by mark ! or dotted Les composants identifiés par une marque ! sont line with mark ! are critical for safety.
TA-N9000ES 5-5. SCHEMATIC DIAGRAM – MAIN Section (3/3) – • See page 10 for IC Block Diagram. (Page 16) (Page 16) (Page 21) (Page 25) (Page 25) (Page 25) (Page 21) (Page 14) (Page 16) The components identified by mark ! or dotted Les composants identifiés par une marque ! sont...
TA-N9000ES 5-9. SCHEMATIC DIAGRAM – POWER Section – (Page 18) (Page 18) (Page 18) (Page 21) The components identified by mark ! or dotted Les composants identifiés par une marque ! sont line with mark ! are critical for safety.
4-211-108-21 PANEL, FRONT (GOLD) (US, Canadian) 4-211-110-11 CASE (BLACK) SP FRNT Front speaker on/off relay drive signal output terminal (for protect) “L”: relay on 4-942-568-41 EMBLEM (NO.5), SONY (FOR BLACK) * 10 A-4414-841-A CONTROL BOARD, COMPLETE — Power supply terminal (+5V)
Page 19
supplied supplied (2) CHASSIS SECTION supplied supplied supplied 51 51 CNJ 801 supplied US, Canadian supplied supplied CNJ 801 supplied EXCEPT supplied US, Canadian supplied supplied supplied supplied supplied supplied supplied supplied supplied supplied The components identified by Les composants identifiés par une mark ! or dotted line with marque ! sont critiques pour la mark ! are critical for safety.
AC-SW BIAS-C BIAS-FL SECTION 7 ELECTRICAL PARTS LIST BIAS-FR BIAS-RL NOTE: • Due to standardization, replacements in the • Items marked “*” are not stocked since they The components identified by mark ! or dotted line with mark parts list may be different from the parts speci- are seldom required for routine service.
Need help?
Do you have a question about the TA-N9000ES and is the answer not in the manual?
Questions and answers