Reset To Factory Default Settings - Axis Q7436 User Manual

AXIS Q7436 Video Encoder Blade
System Options
NOTICE
NOTICE NOTICE
Improper use may cause unexpected behavior and loss of contact with the Axis product.
Axis strongly recommends that you do not use this function unless you understand the consequences. Axis Support does not provide
assistance for problems with customized scripts.
To open the Script Editor, go to System Options > Advanced > Scripting. If a script causes problems, reset the product to its
factory default settings, see page 49.
For more information, see www.axis.com/developer
File Upload
Files, for example web pages and images, can be uploaded to the Axis product and used as custom settings. To upload a file, go
to System Options > Advanced > File Upload.
Uploaded files are accessed through http://<ip address>/local/<user>/<file name> where <user> is the
selected user group (viewer, operator or administrator) for the uploaded file.
Plain Config
Plain Config is for advanced users with experience of Axis product configuration. Most parameters can be set and modified from this
page. Help is available from the standard help pages.
To open Plain Config, go to System Options > Advanced > Plain Config. Axis Support does not provide assistance.

Reset to Factory Default Settings

Important
Reset to factory default should be used with caution. A reset to factory default will reset all settings, including the IP
address, to the factory default values.
Note
The installation and management software tools are available on the CD supplied with the product and from the support
pages on www.axis.com/techsup
To reset the product to the factory default settings:
1. Press and hold the control button and the restart button at the same time.
2. Release the restart button and hold the control button.
3. Keep the control button pressed until the power LED indicator turns green and the 6 status LED indicators turn amber
(this may take up to 15 seconds).
4. Release the control button. When the status LED indicators display green (which can take up to 1 minute) the process is
complete and the unit has been reset.
5. Using the installation and management software tools, assign the IP addresses, set the password and access the video
stream.
Note
To reset a single channel to the original factory default settings, use the button provided in that unit's web interface.
It is also possible to reset parameters to factory default via the web interface. Go to Setup > System Options > Maintenance.
49