Dell PowerConnect 3248 System User's Manual page 32

CLI Commands
The following table summarizes the equivalent CLI commands for items in the VLAN/VLAN Membership page.
Command
vlan database
vlan vlan-id [name vlan-name]
media ethernet [state {suspend |
active}]
interface vlan vlan-id
switchport allowed vlan {add
vlan-list [tagged | untagged] |
remove vlan-list}
switchport forbidden vlan {add
vlan-list | remove vlan-list}
show vlan [id vlan-id | name vlan-
name]
Example
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#exit
Console(config)#interface ethernet 1/1
Console(config-if)#switchport allowed vlan add 105,7,9 tagged
Console(config-if)#exit
Console(config)#exit
Console#show vlan id 105
VLAN Name Status Ports/Channel groups
---- ----- -------- --------------------------------
105 RD5 active Eth1/ 1 Eth1/ 2 Eth1/ 3 Eth1/ 4 Eth1/ 5
Eth1/ 6 Eth1/ 7 Eth1/ 8 Eth1/ 9 Eth1/10
Console#
Port Settings
On the Port Settings page, you can specify the default port VLAN ID (PVID) for each port on your switch. All untagged packets entering the switch are tagged
by default with the ID specified by the port's PVID.
The Port Settings page is set up in a table format. For each port listed in the Port column, the following options are available:
PVID — Specifies the VLAN ID assigned to untagged frames received on the port. To assign a VLAN ID as the port's PVID, the port must be an untagged
l
VLAN member.
Usage
Allows you to enter VLAN database mode.
Configures a VLAN.
Use the no form command to restore the default or delete a VLAN.
Allows you to enter interface configuration mode for VLANs and to
configure a physical interface.
Configures untagged and tagged ports.
The parameter vlan-list is the list of VLAN identifiers being added.
Separate nonconsecutive VLAN identifiers with a comma and no spaces;
use a hyphen to designate a range of IDs.
Configures forbidden VLANs for a port.
Shows VLAN information.