System Set-Up - Kenwood TK-7160 Service Manual

5. INSTALLATION PLANNING – CONTROL STATIONS
5-1. Antenna system
Control station. The antenna system selection depends on
many factors and is beyond the scope of this manual. Your
KENWOOD dealer can help you select an antenna system
that will best serve your particular needs.
5-2. Radio location
Select a convenient location for your control station radio
which is as close as practical to the antenna cable entry point.
Secondly, use your system's power supply (which supplies
the voltage and current required for your system). Make sure
sufficient air can flow around the radio and power supply to
allow adequate cooling.
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and align-
ment procedures contained in this manual.

SYSTEM SET-UP

Merchandise received
License and frequency allocated by FCC
Choose the type of transceiver
Transceiver programming
Horn alert/P.A. relay
KES-3
External
speaker
(Option)
You can install either KAP-2 or KCT-39 to the transceiver.
GENERAL / SYSTEM SET-UP
Frequency range (MHz)
See page 5.
A personal computer (IBM PC or compatible), programming interface (KPG-46),
and programming software (KPG-99D) are required for programming.
KAP-2
unit
(Option)
KES-5
External
speaker
(Option)
Delivery
NOTE
If you do not intend to use the 3.5-mm jack for the external
speaker, fit the supplied speaker-jack cap to stop dust and
sand from getting in.
Antenna
connector
RF power
136~174 25W
KCT-39
Connection cable
(Option)
KCT-36
Extension cable
KGP-2A
Modem GPS receiver or
or
KGP-2B
Modem GPS controller
(Option)
TK-7160
External
speaker
jack
Power input
connector
Type
K,M
KCT-18
Ignition sense cable
(Option) (Option)
KDS-100
Mobile data
terminal
(Option)
3