Panasonic TH-50PB2W Operating Instructions Manual page 35

Standby pen charging mode
Sets the power supply for the electronic pen charging terminal (CHARGE, MEMORY/(CHARGE)) in the standby mode
(power OFF with remote control).
Off: Turns off the charging terminal power in the standby mode.
On[4hrs]: Turns ON the charging terminal power for 4 hours after entering standby mode.
On: Leaves the charging terminal power ON in standby mode so that the pen can be charged.
Pairing
Registers an electronic pen to electronic pen adapter.
Up to four electronic pens can be registered for an electronic pen adapter.
For the details of the pairing, please refer to "Operating Instructions, Electronic Pen Operations".
Note:
Make sure the electronic pen adapter is connected to the display.
If no electronic pen has been registered, the screen of procedure
on the screen to register an electronic pen.
1
Select "Pairing" in "Touch-Pen Settings" and press
button.
2
Select "Pairing" and press
Pairing Tool
Pairing
Unpairing All
Close
3
While pressing both the remote drawing and the remote
clearing buttons of the electronic pen, press the Power
switch.
To cancel the paring, select "Cancel".
Pairing in progress
Set the electronic pen that you want to pair as
pair-enabled and then move it closer to the
electronic pen adapter. For details, refer to the
procedure for registering electronic pens in the
operating instructions for the electronic pen.
Cancel
[Unpairing]
Unpairs all paired electronic pens.
1
Select "Unpairing All" in "Pairing Tool" and press
2
Select "Yes" and press
Pairing Tool
Do you want to cancel all pairings?
Yes
button.
button.
No
Touch-Pen Settings
3
appears fi rst. Follow the instructions
4
When the electronic pen paring is completed,
select "Return" and press
Pairing Tool
Pairing was successful.
5
Select "Close" and press
Pairing Tool
Unpairing All
button.
button.
Return
button.
Pairing
Close
35