Kenmore 24" (61 cm) Wall Oven Installation Instructions Manual page 6

5. Cabinet Installation
A. 24" and 27", Single and Double Ovens
Insert appliance into cutout. Use the screws provided
to fasten the front frame of the appliance to the
cabinet. The mounting holes in the front frame of
appliance may be used as a template to locate the
appliance mounting screw holes.
To fasten the appliance to the cabinet:
1. Line up the 2 mounting holes on the decorative
trim (ventilation) (taped to the oven side panel)
with the lower mounting holes on each side of the
oven frame, below the oven door (see figure 7).
2. Use 2 screws from the miscellaneous parts bag to
secure the decorative trim (ventilation) and
appliance to the cabinetry.
3. Use the remaining 2 screws for mounting the
appliance in the upper two mounting holes on
each side of the oven frame, above the door.
MOUNTING
DECORATIVETRIM
(VENTILATION)
/
MOUNTING
SCREW
Figure 7
B. 30", Single and Double Ovens
The wall oven can tip when the door
is open. The mounting brackets supplied with the
wall oven must be attached to the cabinet and the
appliance to prevent tipping of the wall oven and
injury to persons.
Mounting Brackets Installation Instructions
1. Unpack the wall oven and find the 2 mounting
screws included in the literature package. The door
may be removed to facilitate handling (see the
Owner's Guide for instructions).
,
The mounting brackets are temporarily installed under
the decorative side trims of the oven when shipped
(see Figure 8 or 9 ). Remove the mounting brackets
from the unit side frame using a No. 2 Robertson@
screw driver (square drive preferred, however a No. 2
Phillips@or Quadrex@ screw driver can also be used).
Open the door to remove the screws, located at the
upper end of the side trim.
Cutout Dimensions
< 28 1/2" (72.4 cm) Min.* >
29" (73.7 cm) Max.*
r
I I
I
,!/14 28 1/16" (71.3cm) Min. /,I I
- 295/s"/75 2cm> M ax "--',
Ilql < / " " I11
p , /
21 1/4" [
54.ocm)|
_._-WoodShims(ifNeeded) P==_q
* RecommendedCutout Width is 28 1/2" (72.4 cm)
Figure 8
30" SINGLE OVEN
T
27 1/4"
(71.8 cm) Min.
28 7/8"
(73.3 cm) Max.
Cutout Dimensions
28 1/2" (72.4 cm) Min.*
29" (73.7 cm) Max.*
r
I
28 1/16" (71.3 cm) Min.
I 179 7/16"/74.8 cm/Ma×.'
8 / ,y
Mounting Brackets
42 3/4"
108.6 cm)
42
(106.7 cm)
49 1/8"
1(124.8 cm) Min.
m 49 3/4"
I(126.4 cm) Max.
_=_Wood Shims (If Needed)J =_-'J
* RecommendedCutout Width is 28 1/2" (72.4 cm)
Figure 9
30" DOUBLE OVENS
6