Setting Up Sources - Meridian 861 User Manual

CONFIGURING THE
DIGITAL SURROUND
CONTROLLER

Setting up sources

This section explains how to use Gain/Sub mode to set up the sources
connected to the digital surround controller, and confi gure them to suit
your other equipment.
You can also adjust the subwoofer crossover frequency to suit the
subwoofers in your system.
To turn on Gain/Sub mode
• Put the digital surround controller into standby by pressing Off (front
panel or remote).
• Press and hold the Confi gure key under the front panel for at least fi ve
seconds.
The display shows:
The digital surround controller will then return to standby with Gain/Sub
mode turned on.
Gain/Sub mode adds two extra options to the DSP parameter menus:
Sensitivity and Xover.
To turn off Gain/Sub mode
• Repeat the above procedure until
the display shows:
To adjust the sensitivity of a source
To obtain the best signal-to-noise ratio for your analogue sources you can
adjust the sensitivity of each input to give the highest level that does not
produce clipping.
• Turn on Gain/Sub mode, as described above.
• Select the source you want to adjust, with loud source material playing.
• Press < or > (remote or under the front panel) until the display shows
the current sensitivity.
For example:
• Press A or V (remote or under the front panel) to change the sensitivity.
Gain/Sub On
Gain/Sub Off
Radio 2.0V In
55