Led Status - Barco RLM W6 User Manual

Simple troubleshooting and definition of the LED indicators
1. During projection, the lamp
suddenly goes off and the
picture disappears.
2. The lamp does not turn on
even when the projector
has been turned on.

LED STATUS

ON
STAND BY
Turns blue
The indicator is off
ON
Turns green
Flashes in green
The indicator is off
ERROR
Flashes once in red
Flashes twice in red
Flashes three times in red
Flashes four times in red
Flashes five times in red
Standby
Cooling / Warm up
Power on / Normal
Lamp fall
Lamp door open
Fan fail
Over Temperature
System Error
The lamp might have been damaged; check the
LED indicator on the rear panel of the projector
and see if it is blinking in red.
ERROR
LED STATUS
Indicates that the projector is in standby mode; this also
means the p rojector has not been turned on by pressing the
SOFT POWER button but has been connected to power.
This indicates that the projector has either been turned on
and is working normally or the projector is not connected to
power.
This indicates that the projector has been turned on and is
working normally.
This indicates that the projector is currently warming up or
cooling down and will not respond to button operations.
This indicates that the projector is currently in stand by mode.
The projector lamp is faulty; check to see if the lamp
is damaged or if it hasn't been properly installed.
The lamp cover is not properly replaced.
The cooling fan inside the projector is not working;
seek assistance from a qualified service personnel.
The projector temperature is too high; try cleaning
the ventilator slots or unplugging the power cord to
resolve the issue.
The projector filter might not have been inserted
properly; check the ventilation slot and make sure the
filter has been properly replaced and inserted.
Blue Green
(STAND BY) (ON)
The lamp has reached the end of its service life;
please replace it.
STAND BY
Red
(ERROR)
repeat
repeat
8
repeat
repeat
53