Adjusting Running Mat Tension/Alignment - York Fitness Treadmill Owner's Manual

Adjusting Running Mat Tension
The tension of the mat has been pre-set at the factory; however, with
use, the mat can stretch slightly and become loose. If the mat is too
loose you will find it starts to slip during use. To tighten the mat:
1. Set the treadmill to run at 3km/h
2. Locate the adjustment screws at the end of the treadmill (there's
one on each side - see diagram below)
3. Using the allen key provided, adjust both screws by 1/2 turn
clockwise
4. Re-test the mat tension. If the mat still slips, repeat step 3
TIP: when correctly tensioned you should be able to lift the edge of
the mat about 5 - 7 cm - please only check this when the power is
turned off.
Adjusting Running Mat Alignment
The alignment of the mat has been pre-set at the factory, however,
the mat can be caused to run out-of-line by a user's running style (eg,
more weight on one foot), or if it placed on an uneven surface - so
it may need adjusting from time to time. If the mat is running out of
alignment it will track towards either the left or right hand side of the
running deck. To re-align:
1. Set the treadmill to run at 3km/h
2. Locate the adjustment screws at the end of the treadmill (there's one on each side - see diagram above)
3. If your mat moves to the right, using the allen key provided adjust the right screw by 1/2 turn clockwise (if it tracks to the left, perform
the same operation on the left screw)
4. Let the treadmill run for a minute to see if it re-aligns to the centre. If more adjustment is needed repeat step 3.
Check Lubrication Before Adjusting the
mat as symptoms can be smaller
If the mat is too
tight, turn the
screws anti-clockwise
Do not over tighten the
mat - only turn the screws
1/2 turn before re-checking
the mat
15