Scan For Device Codes - Dish Network Satellite Receiver User Manual

Chapter 3
Using the System
Page 78
6. If you want to program
Limited Mode, press 1. If not,
skip to step 7.
7. Press the POUND (#) button.
8. Press the blank POWER
button to turn off the device. If
the device does not turn off,
go to step 10.
9. Turn the device back on and
try some other appropriate
buttons to make sure they
work. If the code works for
other buttons, stop here.
10. If the code doesn't work,
repeat steps 3 through 9 with
another device code from the
Device Code tables.
11. If you are unable to find a
code that works, try Scan for
Device Codes (below).

Scan for Device Codes

If the code for your device is not listed in the Device Codes tables starting on
page 101, use this procedure to scan the remote control's memory for the
device code.
1. Turn the device on.
2. Press and hold the mode
button until all the other mode
buttons light up, and then
release the button.
The mode button flashes.
3. For AUX mode only:
• Press 0 for a second TV.
• Press 1 for a second VCR
or DVD player.
• Press 2 for a tuner or
amplifier.
4. For AUX mode only: Press the STAR (*) button.
5. Press the blank POWER
button.
See Limited Mode for more
information.
If you entered the code correctly, the
mode button flashes three times.
If the code works, the device should
turn off.
Sometimes the blank POWER
button works when other buttons
don't.
Try every code listed for your brand
until one works for your device.
Use the device's front panel buttons
or its remote control.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let
go, the TV mode light flashes.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you're not programming in AUX
mode, skip to step 4.
This puts your remote in the scan
mode.