Enabling Disk Overwrite - HIKVISION DS-7604 Series User Manual

User Manual of DS-7604 Series DVR
A newly installed hard disk drive (HDD) must be first formatted before it can be used with your DVR.
Formatting the disk will erase all data on it.
To format a new disk:
1. Enter the Disk Management menu, shown in Figure 54 by going to Main Menu > System
Configuration > Disk Management.
2. Select a disk to format. A disk that has not been formatted will show Error Detected as its status.
If the disk is one that is newly installed, the status of the drive will show up as Non-Active and
the Reformat button will change to the Add button.
3. Click the Reformat/Add button.
4. A confirmation message, similar to the one shown in Figure 55 will appear on the screen. Click
the Yes button to continue formatting process.
5. A format progress bar (Figure 56) will be shown on the menu. After the disk has been formatted,
the status of the disk will change to Active.
6. Click the Done button to exit out of Disk Management.

Enabling Disk Overwrite

Enabling disk overwrite will allow the DVR to overwrite the installed disks once the disks are full.
To enable disk overwrite:
1. Enter the Disk Management menu, shown in Figure 54 by going to Main Menu > System
Configuration > Disk Management.
2. Check the Overwrite checkbox.
3. Click the Save button.
Figure 55. Disk Format Confirmation
Figure 56. Disk Format Progress Bar
67