Fujitsu AD11 Manual page 52

AD11 Mainboard Manual
Onboard Serial Port 2
If the serial port 2 uses the onboard I/O controller, you can modify your
serial port parameters. If an I/O card needs to be installed, COM3 and
COM4 may be needed. The options are: 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3,
3F8/IRQ4, Disabled.
UART 2 Mode
Select an operating mode for the second serial port. Set at
Standard, if you use COM2 as the serial port as the serial port,
instead as an IR port. The options are: Standard, HPSIR, ASKIR.
Onboard Parallel Port
Allows you to select from a given set of parameters if the parallel port uses
the onboard I/O controller.
The options are: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled.
Onboard Parallel Port Mode
Allows you to connect with an advanced printer.
The options are: Normal, EPP, ECP, ECP/ ECP.
ECP Mode Use DMA
This feature allows you to select Direct Memory Access (DMA) channel if
the ECP mode selected. The options are: 3, 1.
Parallel Port EPP Type
This feature allows you to select the EPP type for the parallel port.
The options are: EPP1.9, EPP1.7.
Onboard Legacy Audio
Select an operating mode for the second serial port. Set at
Standard, if you use COM2 as the serial port as the serial port,
instead as an IR port. The options are: Enabled, Disabled.
Sound Blaster
This feature allows you to set audio to Sound Blaster mode, if the onboard
Legacy audio chosen. The options are: Enabled, Disabled.
3 - 16