SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, discharge guard, or other safety devices in place and WARNING: In order to prevent ac ci - working.
Page 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to • Keep all nuts and bolts tight to be sure the equipment the presence of children.
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. Gasoline Capacity 1.50 Gallons and Type: Unleaded Regular • Follow a regular schedule in maintaining, caring for and using your tractor. Oil Type (API-SG-SL): SAE 10W30 (above 32°F) SAE 5W-30 (below 32°F) •...
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.
Page 7
ASSEMBLY INSTALL SEAT (See Fig. 3) NOTE: You may now roll or drive your tractor off the skid. Follow the ap pro pri ate instruction below to remove the Adjust seat before tightening adjustment knob. tractor from the skid. • Remove adjustment knob and cup washer securing seat to cardboard packing and set aside.
Page 8
ASSEMBLY CHECK TIRE PRESSURE ATTACH HOOD SCOOP (See Fig. 4) The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance. • Reduce tire pressure to PSI shown on tires. CHECK DECK LEVELNESS For best cutting results, mower housing should be properly leveled.
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. HIGH FAST SLOW REVERSE NEUTRAL CHOKE IGNITION SWITCH ENGINE START ENGINE ON PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF REVERSE OPERATION SYSTEM (ROS)
Page 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. FIG.
Page 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses.
Page 12
OPERATION TO MOVE FORWARD AND BACKWARD TO ADJUST GAUGE WHEELS (See Fig. 11) (See Fig. 9) Gauge wheels are prop er ly ad just ed when they are slight ly off the ground when mower is at the desired cutting height The direction and speed of movement is controlled by the in operating position.
OPERATION TO TRANSPORT ROS "ON" POSITION ENGINE "ON" POSITION (NORMAL OPERATING) • Raise attachment lift to highest position with at tach ment lift control. • When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position. •...
OPERATION MOWING TIPS CAUTION: Alcohol blended fuels (called gas- • Mower should be properly leveled for best mowing per- o hol or using ethanol or methanol) can attract for mance. See "TO LEVEL MOWER HOUSING" in the moisture which leads to sep a ra tion and for- ma tion of acids during storage.
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH SEASON STORAGE SCHEDULE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure Check Operator Presence & ROS Systems Check for Loose Fasteners Check/Replace Mower Blades Lubrication Chart Check Battery Level Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness...
MAINTENANCE TRACTOR BLADE CARE For best results mower blades must be sharp. Re place Always observe safety rules when per form ing any main- bent, worn or damaged blades. te nance. BRAKE OPERATION CAUTION: Use only a replacement blade approved by the manufacturer of your If tractor requires more than five (5) feet to stop at highest tractor.
Page 17
MAINTENANCE BATTERY TO CHANGE ENGINE OIL (See Figs. 15 and 16) Your tractor has a battery charging system which is suf fi cient Determine temperature range expected before oil change. for normal use. However, periodic charging of the battery All oil must meet API service classification SG-SL. with an automotive charger will extend its life.
MAINTENANCE IN-LINE FUEL FILTER (See Fig. 17) CLEAN AIR SCREEN The fuel filter should be replaced once each season. If fuel Air screen must be kept free of dirt and chaff to prevent filter becomes clogged, ob struct ing fuel flow to car bu re tor, engine dam age from overheating.
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: • Depress clutch/brake pedal fully and set parking brake. • Place gearshift lever in neutral (N) position. • Place attachment clutch in “DISENGAGED” position. •...
Page 20
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO • Insert end of link (E) into hole in front mower bracket CHASSIS - Position hole in arm over pin (B) on outside and secure with washer and retainer spring (J). of tractor chassis and secure with retainer spring.
Page 21
SERVICE AND ADJUSTMENTS TO LEVEL MOWER • If adjustment is necessary, see steps in Visual Adjust- ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the sides are equal.
Page 22
SERVICE AND ADJUSTMENTS TO REPLACE MOWER DRIVE BELT TO REPLACE MOTION DRIVE BELT (See Fig. 28) (See Fig. 29) Park the tractor on level surface. En gage parking brake. MOWER DRIVE BELT REMOVAL For as sis tance, there is a belt installation guide decal on •...
Page 23
SERVICE AND ADJUSTMENTS TO START ENGINE WITH A WEAK BATTERY FRONT WHEEL TOE-IN/CAM BER (See Fig. 31) Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber WARNING: Lead-acid batteries gen- are not adjustable.
SERVICE AND ADJUSTMENTS TO REPLACE HEADLIGHT BULB INTERLOCKS AND RELAYS • Raise hood. Loose or damaged wiring may cause your tractor to run • Pull bulb holder out of the hole in the backside of the poorly, stop running, or prevent it from starting. grill.
STORAGE ENGINE Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. FUEL SYSTEM IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS WARNING: Never store the trac tor with FROM FORMING IN ES SEN TIAL FUEL SYSTEM PARTS SUCH gas o line in the tank inside a building AS CARBURETOR, FUEL FIL TER, FUEL HOSE, OR TANK...
TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Will not start Out of fuel. Fill fuel tank. Engine not “CHOKED” properly. See “TO START ENGINE” in Operation section. Engine flooded. Wait several minutes before attempting to start. Bad spark plug. Replace spark plug. Dirty air filter.
Page 27
TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Engine dies when Reverse operation system Turn ignition key to tractor is shifted (ROS) is not "ON" while ROS "ON" position. into reverse mower or other attachment See Operation section. is engaged. Engine continues to run Faulty operator-safety presence control system.
Page 29
TRACTOR - - MODEL NUMBER YT1942 (96043002501), PRODUCT NO. 960 43 00-25 SCHEMATIC SCH10 BATTERY SOLENOID STARTER FUSE AMMETER BLACK (OPTIONAL) WHITE WHITE ATTACHMENT CLUTCH (CLUTCH OFF) BLACK CLUTCH/BRAKE GRAY (PEDAL UP) REVERSE SWITCH BLACK (NOT IN REVERSE) BLACK BLACK...
Page 30
TRACTOR - - MODEL NUMBER YT1942 (96043002501), PRODUCT NO. 960 43 00-25 ELECTRICAL T02K With 12V Outlet Option With Service Minder Option...
Page 31
TRACTOR - - MODEL NUMBER YT1942 (96043002501), PRODUCT NO. 960 43 00-25 ELECTRICAL PART DESCRIPTION 532 16 34-65 Battery 874 76 04-12 Bolt Hex Head 1/4-20 x 3/4 532 19 32-28 Box Battery 532 17 61-38 Switch Interlock Push-In 532 40 02-52...
Page 32
TRACTOR - - MODEL NUMBER YT1942 (96043002501), PRODUCT NO. 960 43 00-25 CHASSIS chassis-tex_52-gt-husq...