Ground Rules; Connection Diagram - Numark CDN88 Reference Manual

GROUND RULES

1. Make sure all items listed in the BOX CONTENTS section are included in the box.
2. READ SAFETY & WARRANTY INFORMATION BOOKLET BEFORE USING THE PRODUCT.
3. Study the connection diagram in this guide.
4. Place CDN88 MP3 and mixer in an appropriate position for operation.
5. Make sure all devices are turned off and all faders and gain knobs are set to "zero."
6. Connect all stereo input sources as indicated in the diagram.
7. Connect the stereo outputs to power amplifier(s), tape decks, and/or other audio sources.
8. Plug all devices into AC power.
9. Switch everything on in the following order:
•
CDN88 MP3 and other audio input sources (i.e. turntables, CD players, etc.)
•
Mixer
•
Last, any amplifiers or output devices
10. When turning off, always reverse this operation by:
•
Turning off amplifiers
•
Mixer
•
Last, CDN88 MP3 and other audio input sources

CONNECTION DIAGRAM

A typical connection with a mixer is illustrated below.
1. Mount the units in your console or rack with 19" EIA rails.
2. The transport should be mounted not to exceed an angle of 15 degrees (Fig. A).
3. Your CD player can be affected by excess vibration so mount the units in a secure
environment if possible.
4. Connect the supplied Control Cables (Fig. B) between the CD Remote and CD
Transport unit.
5. Connect the line output connections using the supplied audio cables (Fig. C) from the
CD Player to the line inputs of your mixer.
6. Connect fader start cable (Fig. D, optional, not included). Attach your CD play to a
similarly equipped DJ mixer. (This connection can also be used with a remote switch.)
7. Connect the IEC power cord to an appropriate power source. In the US and Canada,
be sure to use a polarized power cord and outlets.
3
Fig. A
Fig. B
Fig. C
Fig. D