Advertisement
Quick Links
These warnings are provided in the interest of safety. You must read them
carefully before installing or using the appliance. It is most important that this
instruction book should be retained with the appliance for future reference.
The instruction book is divided into two parties:
I - FOR THE USER
description of the appliance
use
maintenance and cleaning
warning
II - FOR THE GAS INSTALLER
installation
adapting to different gas and adjusting
page
1
3
7
9
page
10
12
1
DESCRIPTION OF THE APPLIANCE
DIMENSIONS:
E
OVE
1
2
3
8
4
5 6 7
Dimensions
W
H
h
D
h
H
N
N
W
D
PRESENTATION:
• Body of painted steel
• Pan support of enamelled steel bars
• Hob of enamelled steel
• Burners cap of enamelled steel
HOB:
• Power of burners:
cooker 4 burners
1700 W
2600 W
SAFETY OVEN:
cm
55
55
82
135
9
2600 W
950 W
Advertisement
Related Manuals for Zanussi ZC 550 ML
Summary of Contents for Zanussi ZC 550 ML
- Page 1 These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. It is most important that this instruction book should be retained with the appliance for future reference. DESCRIPTION OF THE APPLIANCE DIMENSIONS: 5 6 7 Dimensions...
- Page 2 Pastry tray of aluminium Oven grate - nickled steel maximum flow CONTROL PANEL minimum flow MODEL ZC 550 ML OVEN ELECTRON IC IGNITION: The appliances are fitted with electronic ignition of top burners. To light TOP IGN ITION the selected burner you have just to turn the knob on position "maximum flow", O VEN and to push the ignition knob "...
- Page 3 If the appliances are fitted also with the oven burners electronic ignition (oven + grill) and with a thermostat for maintaining an even temperature in the oven, to light the oven burner, you have just to turn the knob to left to position“8” and to GRILL BURNER push the ignition knob "...
- Page 4 MAINTENANCE AND CLEANING LIGHT IN THE OVEN (on certain models): Before cleaning turn off the gas supply. A frequent maintenance makes the Use: For checking the dish without opening the oven door push the knob marked cleaning easier. " " and light will be on. BODY OF THE GAS COOKER: STORING COMPARTMENT Clean it with a wet sponge with liquid non-corrosive detergent.
- Page 5 CHANGE OF BULB: Stop the power supply. Unscrew the bulb glass protector. Unscrew the bulb and replace it with one of the same type E14, 220V, 15W, 300ºC. Fix the protector in place. GREASING OF TAPS: IMPORTANT ! It can happen sometimes that a tap turns with difficulty or even block. In such cases the tap interior must be cleaned and greased.
- Page 6 INSTALLATION For the installer and qualified technicians CONNECTION TO THE GAS SUPPLY The gas cooker can be connected to the gas supply on the right side. The gas inlet on the appliance is a 1/2" gas parallel male type. There are 3 possibilities for connecting It is mandatory that all operations required for the installation and maintenance be −...
- Page 7 ADAPTING TO DIFFERENT GAS AND ADJUSTING The burners can be adapted to different types of gas by mounting nozzles to the type of gas in question. After, it will necessary to regulate the primary air and adjust the minimum flow. CHANGING OF NOZZLES CHANGING OF NOZZLES FOR HOB remove the pan supports and the burners...
- Page 8 OVEN BURNER − Remove the oven bottom. − Light the burner (knob on position max-flow or 8) and leave the oven door closed for about 10 min. − Turn the knob slowly to position min-flow or 1. air adjusting fixing screw −...