Summary of Contents for Electra Accessories Scoot-N-Go 88700
Page 1
OPERATOR OF THIS PRODUCT BE 16 YEARS OF AGE OR OLDER. ELECTRIC SCOOTER Assembly and User's Manual Model#: 88700 / 88701 / 88702 / 88703 / 88705 / 88615 For the most recent version of this user's manual and for all updated product information please visit www.electrausa.com or call...
Page 2
YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THE SCOOT - N - GO™. TO DETERMINE IF COVERAGE IS PROVIDED YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.
9. Never hitch a ride by holding on to another vehicle. NEITHER ELECTRA ACCESSORIES NOR THE RETAIL SELLER OF THE SCOOT - N - GO™ IS RESPONSIBLE FOR THE CONSEQUENCES OF FAILURE TO COMPLY WITH STATE AND LOCAL ORDINANCES RELATING TO THE USE OF THE SCOOT - N - GO™...
Page 7
GENERAL SAFETY GUIDELINES & RESTRICTIONS HELMET USE WHILE RIDING THE SCOOT - N - GO™ Your state DMV, or the city or county where it will be used, may require that you use a helmet that meets the federal Department of Transportation "DOT" requirements (like those used by motorcycle riders) while riding the SCOOT - N - GO™.
Page 8
Electra customer service a 1-888-467-1234 M-F 10am - 9pm EST. NEITHER ELECTRA ACCESSORIES NOR THE RETAIL SELLER OF THE SCOOT - N - GO™ IS RESPONSIBLE FOR THE CONSEQUENCES OF FAILURE TO COMPLY WITH STATE AND LOCAL ORDINANCES RELATING TO THE USE OF THE SCOOT - N - GO™...
Page 9
GENERAL SAFETY GUIDELINES & RESTRICTIONS BEFORE EACH RIDE: • Make sure you properly (per the instructions in the helmet) wear a helmet that meets DOT or CPSC regulations • Wear protective clothing and gloves • Wear eye protection that does not interfere with your peripheral vision •...
ASSEMBLY INSTRUCTIONS BEFORE ASSEMBLING YOUR SCOOT-N-GO , PLEASE BE SURE YOU HAVE ALL NECESSARY PARTS. REFER TO PAGE #4. PLEASE FOLLOW PROPER ASSEMBLY INSTRUCTIONS. IF YOU DO NOT HAVE THE PROPER PARTS NECESSARY TO ASSEMBLE YOUR SCOOT-N-GO PLEASE DO NOT RETURN THE UNIT TO THE ORIGINAL PLACE OF PURCHASE. CALL ELECTRA CUSTOMER SERVICE AT: 1-888-467-1234 M-F 10am - 9pm EST.
ASSEMBLY INSTRUCTIONS HANDLEBARS INSTALLATION: 1. Insert handlebar post through tightening clamp 2. Insert the top of the fork base into bottom of handlebar post. 3. Line up handlebars and front wheel 4. Slide tightening clamp down to open end of fork base 5.
ASSEMBLY INSTRUCTIONS SEAT INSTALLATION: 1. Insert tapered end of seat post into seat and tighten both seat brackets. 2. Place tightening clamp around the chassis base, insert seat post, adjust for the proper height of the rider, and tighten clamp. 3.
PRE-RIDE ADJUSTMENTS THE REAR BRAKE ON YOUR SCOOT - N - GO™ HAS BEEN PRE-ASSEMBLED AND PRE-ADJUSTED BY THE MANUFACTURER. HOWEVER, THE CABLE AND BRAKE MAY NEED ADJUSTMENT IF IT IS NOT SLOWING OR STOPPING THE SCOOT - N - GO™ PROPERLY. THE BRAKE CAN BE ADJUSTED AT TWO POINTS ON THE THE SCOOT - N - GO™...
PRE-RIDE ADJUSTMENTS TIRE ADJUSTMENTS: IMPORTANT INFORMATION!!! Proper Tire Pressure 45-50 PSI Make sure that the air pressure for all tires is between 45-50 PSI . If the tires have less than the recommended amount of pressure, a decrease in battery usage time, poor handling, and damage to the tires and rims may occur.
PRE-RIDE ADJUSTMENTS DRIVE CHAIN ADJUSTMENTS CHECKING CHAIN TENSION: 1. Make sure key is not in ignition 2. Lay bike on its side to check drive chain 3. Squeeze chain using your thumb and index finger to determine if chain is too loose or too tight. (FIG. 1) 4.
BATTERY BEFORE OPERATING YOUR NEW SCOOT - N - GO™ FOR THE FIRST TIME, THE BATTERY MUST BE FULLY CHARGED! FAILURE TO KEEP THE SCOOT - N - GO ™ BATTERY CHARGED WILL CAUSE TOTAL BATTERY FAILURE. DO NOT ALLOW BATTERY TO BE FULLY DISCHARGED! ONCE CHARGER IS PROPERLY ATTACHED TO SCOOTER AND A SUFFICIENT POWER SOURCE, THE CHARGER INDICATOR LIGHT WILL FLASH INDICATING THE UNIT IS BEING PROPERLY CHARGED.
STARTING INSTRUCTIONS 1. Make sure you have READ ALL SAFETY GUIDELINES AND PRE-RIDE ADJUSTMENTS IN THIS MANUAL 2. Make sure battery is fully charged 3. Check brakes 4. Insert key in ignition and turn right 5. Check throttle 6. Check all lights 7.
SERVICE & MAINTENANCE PATCHING A TUBE IS AN EMERGENCY REPAIR. CARELESS PATCHING OR APPLYING SEVERAL PATCHES CAN SERIOUSLY WEAKEN THE TUBE, RESULTING IN POSSIBLE TUBE FAILURE, WHICH COULD CAUSE YOU TO LOOSE CONTROL AND FALL. REPLACE A PATCHED TUBE AS SOON AS POSSIBLE. 5.
STORAGE STORING YOUR SCOOT - N - GO™ Proper storage preparation is essential for keeping your SCOOT - N - GO™ trouble free and in good working order. The following steps will help you keep rust and corrosion from impairing your SCOOT - N - GO™ functions and appearance.
TROUBLE SHOOTING If your SCOOT - N - GO™ sustains an impact: A CRASH OR OTHER IMPACT CAN PUT EXTRAORDINARY STRESS ON COMPONENTS, CAUSING THEM TO FATIGUE PREMATURELY. COMPONENTS SUFFERING FROM STRESS FATIGUE CAN FAIL SUDDENLY AND CATASTROPHICALLY, CAUSING LOSS OF CONTROL, SERIOUS INJURY OR DEATH. First, check yourself for injuries, and take care of them as best you can.
WARRANTY INFO 30 Day Limited Warranty Electra Accessories, Inc. ("Electra" the distributor) warrants to the original retail purchaser ("you") that the Electra product for which this warranty has been issued is free from defects in material and workmanship for 30 days from the date of original retail purchase.
RECEIPT, FOR A PERIOD OF TEN (10) DAYS FROM THE DATE OF PURCHASE. TO BE ELIGIBLE FOR RETURN OR EXCHANGE, ALL ELECTRA ACCESSORIES SCOOTER PRODUCTS MUST BE IN LIKE NEW CONDITION, IN THE ORIGINAL BOX, ALONG WITH ALL ACCESSORIES THAT INCLUDE, BUT IS NOT LIMITED TO, KEYS, MIRRORS, TOOL KITS, LOCKS, MANUALS, FUSES, CHARGERS, ETC.
Need help?
Do you have a question about the Scoot-N-Go 88700 and is the answer not in the manual?
Questions and answers