Yamaha CDR400t User Manual page 13

Chapter 2 - Installing the Yamaha CDR400t Drive
Parity setting
Parity ON (with a jumper)
— Parity Check will be performed. Normally, use this setting.
Parity OFF (without a jumper)
— Parity Check will not be performed.
Parity ON
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
Terminator setting
The terminator setting indicates whether or not this device is the last
connected SCSI device.
Terminator ON (with a jumper)
— Use this setting if the CDR400t is the last device in the internal
SCSI daisy-chain.
Terminator OFF (without a jumper)
— Use this setting if devices other than the CDR400t are in the inter-
nal SCSI daisy-chain and the CDR400t is not the last device.
Terminator ON
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
Parity OFF
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
Terminator OFF
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
7