Recording And Playback - Yamaha AUDIOGRAM6 Owner's Manual

Recording and Playback

1
Click the Transport panel [Record] button to
begin recording.
When recording is started the project cursor will
begin moving to the right and a box that displays the
recording results will be created.
<Transport panel>
Rewind
Forward
2
Play the part.
3
When you finish recording the track, click
the Transport panel [Stop] button.
Recording with maximum quality and mini-
mum noise:
For optimum sound quality with minimum noise, the
AUDIOGRAM signal levels should be set as high as
possible without clipping. Check signal levels to be
sent to Cubase AI for recording using the AUDIO-
GRAM level indicators while the DAW control is set to
minimum. Adjust the channel LEVEL controls so that
the corresponding PEAK LEDs flash only occasionally
on the highest input transients.
Record
Start
Stop
Recording results
4
To hear playback of the track you have just
recorded, use either the Transport panel
[Rewind] button or the ruler to rewind to the
beginning of the recorded section, then click
the Transport panel [Start] button.
The overall playback level will be displayed via the
master section bus level meter on the right side of the
mixer window, and the channel level will be dis-
played via the channel strip level meter.
NOTE • Click the [Narrow/Wide] button in the upper
left corner of the mixer window to increase
the width of the mixer's channel strips.
• To hear the playback sound via the AUDIO-
GRAM interface, adjust the volume with the
DAW control and MASTER LEVEL control.
The playback level will approximately match
the recording level when the DAW control is
set to about 1 o'clock.
[Narrow/Wide] button
Level meter
5
To save the project file select [Save] from the
[File] menu and enter a file name before actu-
ally saving the file.
Save your project file frequently to insure against los-
ing large amounts of data if a problem occurs.
6
Repeat steps 1 through 5 to record further
material on the same track.
7
To record additional material on a different
track, select a new track and repeat the
record procedure.
AUDIOGRAM 6 Owner's Manual
Quick Guide
[Narrow/Wide] button
Bus level mete
13