Wenger Clock Instruction Manual page 5

Position 1 Position 2
Setting the Time and Date on Standard Watches
(see Table of Contents on p.1 for other watches)
Important note: If the crown of your watch does not pull directly out or if your
watch is water-resistant to 200m, then you may have a watch with a screw-
down crown. Rotate the crown counterclockwise until the crown moves away
from the watch. This will set the crown in Position 1. Always screw down the
crown after making any adjustments. This is very important as the screw-down
crown assures water resistance.
6
Position 3 1. Pull out the crown to Position 2 (one "click" out). Rotate crown counterclock-
wise until the date shows one day earlier than the date you want to set.
2. Pull out the crown to Position 3 (two "clicks" out). Rotate crown so the watch
hands move clockwise until the current date shows. Then set the watch
hands to the correct time. Turn the watch hands past 12 once if you're set-
ting the watch for a P.M. time. Push the crown back to Position 1.
3. For a watch with day and date display, pull out the crown of the watch to
Position 2, turn it clockwise to change the day and counterclockwise to
change the date.
4. Return the crown to the fully depressed Position 1, assuring the crown has
been further screwed down on all 200m watches.
For Watches Without a Date Display
1. To set the time for watch without date display, pull out the crown to
Position 2. Turn the crown either clockwise or counterclockwise to set the
correct time.
2. Return the crown to the fully depressed Position 1, assuring the crown has
been screwed down on all 200m watches.
7