Installing Chute Support; Container Mounting; Mounting Cover Assembly - Husqvarna MZ54 Operator's Manual

2

INSTALLING CHUTE SUPPORT

1. Position upper chute support against bagger inlet,
flush at outer edges. See Illustration.
2. Using support as a template, drill two
bagger hood.
3. Secure upper chute support to hood with hex
bolts, washers and nyloc nuts.
Flex.Trim
6
ASSEMBLY
/ holes into
3
8
Bagger.Inlet
8063-047
Upper.Chute.
Support
8063-048
3

CONTAINER MOUNTING

Remove plastic end caps from the center two bag
support arms. Fully insert spacer plugs into the ends
of the support tubes. It may be necessary to tap the
spacers into place with a hammer or mallet. Replace
the plastic end cap back over the spacer. The
additional extension will hold the hood more securely
when latched.
Spacer
Center.End.Caps
4

MOUNTING COVER ASSEMBLY

NOTE: Assistance from another person may ease
mounting the cover assembly to mower.
1. Lift and rotate cover to align the cover brackets
with support assembly tubes.
2. Slide the cover down over the support tubes until
secure.
8063-049
8063-050