Yamaha EQ-1100 Owner's Manual page 12

■ MANUAL EQUALIZATION
1. Set the EQ CURVE DISPLAY button to ON.
The equalizer levels will be displayed with dots.
If you want to adjust based on your hearing while
observing the spectrum display, set the display mode
for the analyzer mode with the ANALYZER button.
2. Press one of channel buttons to select the channel(s)
to be adjusted.
LEFT: Press to adjust the left channel. RIGHT:
Press to adjust the right channel. L + R: Press to
adjust the left and right channel simultaneously.
3. Set the EQ button to ON.
4. Press the EQUALIZER LEVEL buttons to obtain the
desired equalizer curve.
■ HOW TO STORE EQUALIZER CURVES
IN MEMORY
1. Adjust the equalizer levels.
2. Set the MEMORY button to ON.
The MEMO indicator will flash for about 5 seconds.
3. While the MEMO indicator is flashing, press one of
memory buttons 1 to 4.
* When two or more level setups are stored under one
preset memory button, only the latest setup stored in
memory will be stored.
■ HOW TO RECALL PRESET MEMORY
Press the preset memory button of the memory to be
recalled.
The preset No. indicator lights to show the number of the
button pressed, and the equalizer curve in the memory will
be displayed.
If a memory is recalled while the EQ button is OFF, the
stored equalizer curve will be displayed but the equalizer
effect is not applied.
LAST MEMORY FUNCTION
The button setting and equalizer levels immediately before
turning the power off are stored.
When the POWER switch is pressed ON again, the setting
and levels before power off will be recalled.
MEMORY BACKUP
The button setting and equalizer levels in the last memory
and the equalizer curves stored in the preset memories
are stored even when the power cord has been
disconnected from the outlet, using a capacitor which
backs up these memories for at least 2 weeks. However,
the equalizer curves stored in the fixed memories will not
cleared even after 2 weeks. If the last memory and
preset memories have been cleared after the power has
been off for more than 2 weeks, it is necessary to store
preset memories again.
■ HOW TO SUPERIMPOSE EQUALIZER
CURVES
The curve stored in the ROOM EQ memory button, which
was obtained by auto equalization, can be superimposed
with another curve which has been stored in one of preset
memory buttons 1 to 7.
1. Press the ROOM EQ button. The
ROOM EQ indicator will light.
2. Press the ROOM EQ button again.
Only "P" of the preset memory No. indicator will flash.
3. While "P" is flashing, press one of preset memory
buttons 1 to 7 that is to be superimposed.
■ HOW TO DUB TAPE
1. Select a dubbing mode by the input select buttons.
2. When dubbing equalized sound, press the EQ and EQ
REC buttons, and set the equalizer levels as desired.
3. According to the dubbing mode selected, set one of the
cassette decks to play mode and the other to record
mode.