Advertisement
To keep the holder attached to the
handlebar when you are not using it,
carefully stretch the holder straps over
the handlebar, and thread the straps
behind the tabs on the charger (27).
Make sure the holder stays firmly in
place (28).
Charge the battery using the dynamo
Make sure the charger is connected
to your mobile device.
Press the lever of the dynamo so that
the friction roller touches the tyre.
Begin pedalling your bicycle faster
than 6 km/h (4 mph), which is
Take care of your device
Handle your device and accessories with
care. The following suggestions help you
protect your warranty coverage.
Connect the charger to the
mobile device
Plug the charging cable of the charger
into the 2.0 mm charger connector on
your Nokia device.
If you connect the dynamo to
a headlamp at the same time, your
device will not charge properly.
a typical walking speed. If you pedal
too slowly, charging may not start
even when you increase your speed.
In that case, stop the bicycle, and
detach the charging cable from the
mobile device for a few seconds.
• Keep the device dry. Precipitation,
humidity, and all types of liquids or
moisture can contain minerals that
ENGLISH
Advertisement
