Related Manuals for JVC KD-R326
Summary of Contents for JVC KD-R326
- Page 1 ENGLISH KD-R326/KD-R325 CD RECEIVER / For canceling the display demonstration, see page 4. / For installation and connections, refer to the separate manual. INSTRUCTIONS GET0675-001A [U/UH]...
- Page 2 Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. IMPORTANT FOR LASER PRODUCTS 1. CLASS 1 LASER PRODUCT 2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel.
-
Page 3: Table Of Contents
How to attach/detach the control CONTENTS panel 3 How to attach/detach the control panel 3 How to reset your unit 3 How to forcibly eject a disc 3 Maintenance Canceling the display demonstration How to reset your unit Setting the clock Your preset adjustments will Preparing the remote controller also be erased. -
Page 4: Canceling The Display Demonstration
Canceling the display demonstration Display demonstration will be activated automatically if no operation is done for about 20 seconds. Turn on the power. Select <DEMO OFF>. [Hold] (Initial setting) Finish the procedure. (Initial setting) Setting the clock Turn on the power. [Hold] (Initial setting) Select <CLOCK>. -
Page 5: Preparing The Remote Controller
Preparing the remote controller Caution: When you use the remote controller for the first time, pull out the insulation sheet. • Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. • Battery shall not be exposed to excessive heat Insulation sheet such as sunshine, fire, or the like. -
Page 6: Basic Operations
Basic operations Loading slot Control dial Display window Ejects the disc Remote sensor Front auxiliary input jack • DO NOT expose to bright sunlight. Detaches the panel When you press or hold the following button(s)... Remote Main unit General operation controller •... -
Page 7: Listening To The Radio
Listening to the radio • Auto search [Press]. Ÿ • Manual search [Hold]. “M” flashes, then press the button ] “FM” or “AM” repeatedly. “ST” lights up when receiving an FM stereo broadcast with sufficient signal strength. Improving the FM reception Manual presetting (FM/AM) You can preset up to 18 stations for FM and 6 stations for AM. -
Page 8: Listening To A Disc
Listening to a disc Ÿ Playback starts automatically. ] “CD” All tracks will be played repeatedly until you change the source or eject the disc. Stopping playback and ejecting Selecting a track/folder from the list the disc If the ejected disc is not removed within 15 seconds, it is automatically inserted into the loading slot. -
Page 9: Connecting The Other External Components
Connecting the other external components You can connect an external component to the auxiliary input jack on the control panel (F-AUX) and/or on the rear side of the unit (R-AUX). Summary of using the external components through the auxiliary input jacks: Preparation Connecting Auxiliary... -
Page 10: Selecting A Preset Sound Mode
Selecting a preset sound mode You can select a preset sound mode suitable for the music genre. FLAT = NATURAL = DYNAMIC = VOCAL BOOST = ] <PRO EQ> ] <BASS/ MIDDLE/ BASS BOOST = USER = (back TREBLE> to the beginning) While listening, you can adjust the tone level of the selected sound mode. - Page 11 Menu item Selectable setting, [Initial: Underlined] DIMMER SET AUTO : Dims the display to the previous setting when you turn on the car / ON : Dims the display and button illumination (50% of the selected headlights. * brightness level). / OFF : Cancels (100% of the selected brightness level). BRIGHTNESS DAY [ 31 ] / NIGHT [ 15 ] : Selects the display and button illumination brightness level [00 —...
-
Page 12: Additional Information
Menu item Selectable setting, [Initial: Underlined] LOW POWER : VOLUME 00 – VOLUME 30 (Selects if the maximum power GAIN * of each speaker is less than 50 W to prevent damaging the speakers.) / HIGH POWER : VOLUME 00 – VOLUME 50 SSM * See page 7. -
Page 13: Troubleshooting
UNIT” appears on the display and no with insulating tape properly, then reset the unit. (page 3) operations can be done. If the message does not disappear, consult your JVC car audio dealer or a company supplying kits. The unit does not work at all. -
Page 14: Preparing To Use Bluetooth Device
Using Bluetooth ® devices For Bluetooth operations, it is required to connect the Bluetooth adapter, KS-BTA100 (not supplied) to the auxiliary input jack (R-AUX/BT ADAPTER) on the rear of the unit. (page 9) • For details, refer also to the instructions supplied with the Bluetooth adapter and the Bluetooth device. -
Page 15: Specifications
Specifications AUDIO AMPLIFIER SECTION CD PLAYER SECTION Maximum Power Output : 50 W per channel Type : Compact disc player Continuous Power Output (RMS) : 20 W per Signal Detection System : Non-contact optical channel into 4 Ω, 40 Hz to 20 000 Hz at no pickup (semiconductor laser) more than 1% total harmonic distortion. -
Page 16: Removing The Unit
หากท่ า นมี ค ำถามหรื อ ต้ อ งการข้ อ มู ล เกี ่ ย วกั บ ชุ ด ติ ด ตั ้ ง โปรดปรึ ก ษาตั ว แทนจำหน่ า ยเครื ่ อ งเสี ย งติ ด รถยนต์ • If you have any questions or require information regarding installation kits, consult your JVC car audio •... -
Page 17: Electrical Connections
การเชื ่ อ มต่ อ ไฟฟ้ า ELECTRICAL CONNECTIONS / สายสั ญ ญาณ Signal cord / Rear speakers JVC Amplifier / or subwoofer / แอมพลิ ฟ ลายเออร์ ข อง ลำโพงหลั ง หรื อ ซั บ วู ฟ เฟอร Rear ground terminal / ขั... - Page 18 Having TROUBLE with operation? Please reset your unit Refer to page of How to reset your unit EN, TH © 2010 Victor Company of Japan, Limited 0910DTSMDTJEIN...