Identification Of Controls - Sanyo LED-32XR10F Instruction Manual

Main Unit (front/side view)
1 2
SOURCE MENU
3 4 5
Note: Buttons on the TV control panel
^
(CH / , VOL+/-, MENU, SOURCE, POWER
^
) are touch buttons. First touch of the button
will illuminate it. Second touch will fulfill its
function. Be sure button presses must be
quickly done before the illumination
disappears.
8
Main Unit (back view)
MUSIC/AUDIO D-Sub
RS-232 HDMI 1 HDMI 2 PC IN
6 7 8 9 10

Identification of Controls

1. Remote sensor/Light sensor
Receives signals from the remote control. Do not block.
The light sensor will measure the room brightness, do not put anything
around the sensor.
2. Power indicator
Lights blue when in operating mode.
SOURCE MENU CH VOL
Lights red when in standby mode.
3. POWER
+
CH VOL
Press this button to turn the unit ON from STANDBY mode. Press it
again to turn the set back to STANDBY.
4. SOURCE
6 7
To access SOURCE menu
5. MENU
Press this button to access the main menu screen.
6. CH
Press these two buttons to directly change the TV channel;
In menu operations, these buttons serve as up/down buttons.
7. VOL+
Press the VOL+ or VOL– button to directly increase or decrease
the sound volume level;
In menu operations, these buttons serve as right/left buttons.
8. Power Switch
Y P P L AUDIO R
B R
COMPONENT IN
11
^
/
^
/–
1. Headphone & S/PDIF:
1
Connect headphones to this jack.
Connect a digital sound system to this jack.
2
2. USB port: Connect a USB device to this port.
3
3. HDMI3: Connect an HDMI device to this jack.
4. AV OUTPUT: Connect a VCR to these jacks to record
programs.
4
5. AV INPUT: Connect an AV device to these jacks.
6. RS-232: For service only. Do not use.
5
7. HDMI1: Connect an HDMI device to this jack.
8. HDMI2: Connect an HDMI device to this jack.
9. MUSIC: Connect a MP3 player to this jack.
10. PC IN D-SUB/AUDIO: Connect a computer to these
jacks.
RF
11. COMPONENT IN: Connect a component video device
to these jacks.
12
12. RF: Connect an antenna to this jack.
7