Troubleshooting Guide - Panasonic SC-BTT195 Operating Instructions Manual

[BTT195]
Front speaker assembly option
It is possible to shorten the height of the front
speaker by directly connecting the speaker to the
base without using the stand.
Preparation
Detach the speaker cable from the stand.
1
Thread the detached cable through the
base.
2
Attach the speaker to the base and tighten
the screw (supplied) securely.
3
Connect the speaker cable to the speaker
and to the terminal of the main unit.
( 13, 14)
∫ Reattaching the speaker cable
to the stand
Straighten the
cable and run
through the stand.
42
VQT4A16

Troubleshooting guide

Reference
Before requesting service, please perform the
following checks.
If the problem remains unresolved, consult
your dealer for instructions.
The following do not indicate a problem with
this unit:
– Regular disc rotating sounds.
– Image disturbance during search.
– Image disturbance when replacing 3D discs.
∫ Unit doesn't respond to remote
Press and hold [Í/I] on the main unit for 3 seconds.
– If still unable to turn the unit off, disconnect the
∫ Cannot eject disc.
The unit may have a problem.
1 While the unit is off, press and hold [OK], the
2 Repeatedly press [1] (right) on the remote
3 Press [OK] on the remote control or
To return to the factory preset.
To return all settings to the factory preset.
1 While the unit is off, press and hold [OK], the
2 Repeatedly press [1] (right) on the remote
Pull out the
cable through
the hole.
3 Press and hold [OK] on the remote control or
Do you have the latest firmware installed?
Firmware updates may be released to correct
operating irregularities that are discovered with
certain movies. ( 18)
control or front panel buttons.
AC mains lead, wait 1 minute, then reconnect
the AC mains lead.
yellow button and the blue button on the remote
control at the same time for more than 5 seconds.
j"00 RET" is displayed on the unit's display.
control or [Í/I] on the unit until "06 FTO" is
displayed on the unit's display.
[< OPEN/CLOSE] on the unit.
General operation
Select "Yes" in "Default Settings" in the Setup
menu. ( 38)
Reset the unit as follows:
yellow button and the blue button on the remote
control at the same time for more than 5 seconds.
j"00 RET" is displayed on the unit's display.
control or [Í/I] on the unit until "08 FIN" is
displayed on the unit's display.
[< OPEN/CLOSE] on the unit for at least
3 seconds.