Siemens ATS-150 Installation And Operating Instructions

Brief and handy:
en
everything your dishwasher
needs...
Before using for the first
time, read the installation
and operating instructions!
Fill with special salt
Fill with rinse aid

Fill with detergent

Select programme

Switch on appliance
Press On/Off switch, running time of the
chosen programme appears
Switch off the appliance
When the display shows 0 (end of programme),
press On/Off switch
Set the water softening system *
Find out the water hard-
ness at your water utility
company and enter
* only before using the dish-
washer for the first time or
if the water hardness
changes
Dissolves limescale (not required for set value 0!)
Unscrew
the lid.
Everything is sparkling clean ...
Press mark 1,
lift up lid 2.
Very dirty dishes, a lot of detergent ...
If required, open
the lid (press the
pin).
Quick, economical or intensive ...
Overview of programmes
This overview indicates the max. possible number of
programmes. The programmes which correspond to your
appliance can be found on your appliance fascia.
The programme data are values measured in the
laboratory in compliance with Standard EN 50242.
Deviations is practice are possible.
Additional programmes **
Time selection
...switches on as soon as
you press the time
h.
Everything O.K...
selection button:
Alters the programme
start in hourly steps
Read off the setting ...
A
Only before using
the dishwasher
for the first time
pour approx. 1 l /
2 pt water into the
salt opening.
Warning,
combination
products are not
suitable for all
programmes,
follow manufac-
turer's instructions.
Duration in minutes
Power consumption in kWh
Water consumption in litres
With Aqua sensor
Flexibility ...
Saving time (VarioSpeed) Half load
... for a few items, saves
... is obtained by increased
water, energy and time
energy consumption at
a constant cleaning and
drying performance.
** some models
Quickly sorted ...
and then set
– Hold down programme button B and switch on the main
B C
switch, then release the buttons. The display of button B
and the number 4 set by the factory flash.
Reset
– Each time button B is depressed, the setting increases by
one; if 7 has been reached, the display jumps back to 0.
– Switch off the main switch. The selected setting has been
stored in the appliance.
Pour in max.
1.5 kg / 3 lb 5 oz
salt (never deter-
gent!)
Refill whenever level indicator is light!
Pour in
rinse aid.
Pour in
detergent.
Gentle
Intensive Normal Eco
70_ 65_ 50_ 40_
138 140 140 75
1,65 1,60 1,05 0,90
16 16 12 14
13 – – 11
Screw on the
lid. Switch on
dishwasher
immediately.
Close the
lid. CLICK!
Push the lid
shut, press.
PLOP!
Quick Prerinse
45_
30 19
0,80 0,05
10 4
– –