Troubleshooting - Silvercrest CRB-532 Instructions Manual

20 Troubleshooting

If a fault occurs, please consider these instructions before you have the device repaired. If you are unable to solve a problem
despite these instructions, please ring our hotline. Do not try repairing the device yourself under any circumstances. In that
event, the warranty would be void.
Problem Cause
The frame cannot be The safety screws were not removed.
slid off the device
The release key was not inserted correctly. Reinsert the key. Make sure that the protrusion on the
towards the rear.
The device does not The connection cables have not been
play any music. attached correctly.
The "MUTE" or "pause" button is pressed.
The device cannot be On / off button was pressed too briefly.
turned on.
The operating panel is not inserted
correctly.
The ignition is turned off.
The connection cables have not been
attached correctly.
The fuse is blown.
The device does not The radio has not been connected
retain the stored correctly.
stations.
The device temperature is too high.
Contacts 4 and 7 have not been connected
properly or the vehicle manufacturer has
assigned these in reverse.
CD is not being The two safety screws were not removed,
drawn in completely. or not entirely.
Solution
Please remove the safety screws and try again.
release key points away from the device during the
insertion.
Please check if all cables have been attached correctly.
Press the "MUTE" or "pause" button again.
Keep the on / off button pressed longer.
Reinsert the operating panel.
Turn on the ignition
Please check if all cables have been attached correctly.
Replace the fuse.
Please check if all cables have been attached correctly.
Reduce the volume of the device.
Remove the transparent plugs on the yellow and red
cable and plug them back together crosswise (yellow to
red and red to yellow).
Please remove the safety screws and try again.
127