Panasonic Viera TX-PF42S10 Operating Instructions Manual page 27

Menu Item
Mode
Bass
Treble
Balance
Headphone Volume
Surround
Volume Correction
Speaker Distance to
Wall
MPX
SPDIF Selection
MPEG Optical Level
HDMI1 / 3 Input
Reset to Defaults
●
A different menu will be displayed while PC or SD Card is used. (p. 43 - 45)
●
Only available items can be selected.
Adjustments / Configurations (alternatives)
Basic sound mode (Music / Speech)
Increases or decreases level to enhance or minimise lower, deeper sound output
Increases or decreases level to enhance or minimise sharper, higher sound output
Adjusts volume level of right and left speakers
Adjusts the volume of the headphones
Surround sound settings (Off / V-Audio / V-Audio Surround)
V-Audio: Provides a dynamic enhancer of width to simulate improved spatial effects
V-Audio Surround: Provides a dynamic enhancer of width and depth to simulate
improved spatial effects
●
Switching is also possible by the Surround button on the remote control (p. 9).
Adjusts the volume of individual channel or input mode
Adjusts the low frequency sound (Over 30cm / Up to 30cm)
●
If the back space between the TV and wall is over 30 cm, "Over 30cm" is
recommended.
●
If the back space between the TV and wall is within 30 cm, "Up to 30cm" is
recommended.
Select stereo / monaural (Mono / Stereo)
●
Normally: Stereo
●
Stereo signal cannot be received: Mono
●
M1 / M2: Available while mono signal is transmitted
●
Analogue mode only
Selects the initial setting for digital audio output signal from DIGITAL AUDIO OUT
terminal (Auto / PCM)
Auto : Dolby Digital Plus and Dolby Digital are output as Dolby Digital Bitstream.
HE-AAC (48 kHz) is output as DTS.
MPEG is output as PCM.
PCM : Digital output signal is fixed to PCM.
●
DVB mode or Movie View Mode (p. 44) only
Normally, MPEG sound is larger comparing with the other types of audio track
You can adjust the audio level of MPEG output from DIGITAL AUDIO OUT terminal as
the initial setting (0 / -2 / -4 / -6 / -8 / -10 / -12dB)
●
DVB mode only
Select to fit the input signal (Digital / Analogue) (p. 59)
Digital : HDMI cable connection
Analogue : HDMI-DVI adapter cable connection
●
HDMI input mode only
●
HDMI2 terminal is for digital signal only
●
No setting for HDMI2 available
Press the OK button to reset the present Sound Mode to the default settings
27