Other Problems; No Sound Can Be Heard Or The Sound Is Faint" S; The Remote Control Does Not Work" S; I Want To Change The Language For Messages And Menus" S - Epson EB-1925W User Manual

Problem Solving

Other problems

No sound can be heard or the sound is faint
Check
Is the audio source connected correctly?
Is the volume adjusted to the minimum setting?
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
Is it connected with an HDMI cable? (EB-1925W/1915 only)
The Remote Control does not work
Check
Is the Remote Control light-emitting area pointing towards the
Remote receiver on the projector when it is operated?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining
onto the Remote Receiver?
Is the correct setting for the Remote Receiver selected?
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.s
Are the remote control ID and the projector ID matched?
I want to change the language for messages and menus
Check
Change the Language setting.
Disconnect the cable from the Audio port, and then reconnect the cable.
Adjust the volume so that sound can be heard.s p.56, Quick Start Guide
Press the [A/V Mute] button on the Remote Control to cancel A/V Mute.s
When using a commercially available audio cable, make sure it is labeled "No resistance".
If no audio is output when connecting via an HDMI cable, set the connected equipment to PCM output.
Point the remote control towards the Remote Receiver.
Operating range s Quick Start Guide
The operating range for the remote control is about 8 m.s Quick Start Guide
Set the projector up in a location where strong light does not shine onto the Remote Receiver. Or set the remote
receiver to Off from Remote Receiver in the configuration menu. s Settings Menu - Remote Receiver
Check the Remote Receiver from the Configuration Menu. s Settings Menu - Remote Receiver
Make sure the ID for the projector you want to operate and the ID for the remote control match. To operate all
projectors by remote control regardless of the ID setting, set the remote control ID to "0".s
Adjust the Language setting from the configuration menu. s Extended Menu - Language
Remedy
p.32
Remedy
Remedy
92
p.56
p.56
p.98
p.42
p.58