NEC N8800-164F User Manual page 54

4-6 ESX Setup
<When the AC power is on (The power cords are plugged to the wall outlet)>
(1) Confirm the POWER LED of the CPU/IO module.
(2) Execute the operation to be taken when AC power supply is turned off.
<When the AC power is off (The power cord is not plugged into the outlet)>
Connect the power cords to NEC Express5800/ft series in the following order:
(1) Connect the power cord to the AC inlet A connector.
(2) Connect the power cord to the AC inlet B connector.
(3) Make sure that the CPU/IO module status LED is turned off.
Preparation is now completed.
Rear side of device
If the POWER LED is turned on, shut down the OS and unplug the AC power
cord after the POWER LED turns off.
If the POWER LED is turned off, unplug the AC power cord.
AC Inlet
Connector A
AC Inlet
Connector B