Din Rail Mounting Installation - Korenix JetNet 5310G User Manual

JetNet 5310G User Manual
Note: It is recommended to not plug-in SFP fiber transceiver and link up RJ-45 port at the
same time, it might cause the connection does not working properly.
2.7

DIN Rail mounting Installation

The DIN-Rail clip is already screwed tight on the rear side of JetNet Switch when
shipping. If the DIN-Rail clip is not screwed on the rear side panel, please contact
your distributor to get the DIN rail clip set. The DIN rail clip supports EN50022
standard. The diagram following includes the dimension of EN50022 DIN rail for
your reference.
The Switch should install and used at Restriced Acess Location area, like as the
control room or control cabinet. Besides, the device's surface temperature may
caused damage while the Power over Ethernet function is enabled and under
working , at the ambient temperature -75°C . Therefore, the device should install at
the restriced location, like as Control cabinet to prevent any damage.
18