Vlan Commands Set - Lantech LGS-2404 User Manual

aggregator group
[GroupID] [Port-list]
nolacp
show aggregator
no aggregator lacp
[GroupID]
no aggregator group
[GroupID]

VLAN Commands Set

Netstar Commands
vlan database
Vlanmode
[portbase| 802.1q |
gvrp]
no vlan
Ported based VLAN configuration
vlan port-based
grpname
of member ports.
G Assign a static trunk
group.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
P Show the information
of trunk group
G Disable the LACP
function of trunk group
G Remove a trunk group switch(config)#no aggreator
Level Description
P Enter VLAN configure
mode
V To set switch VLAN
mode.
V No VLAN
V Add new port based
VALN
20
switch(config)#aggregator group
1 2-4 nolacp
or
switch(config)#aggregator group
1 3,1,2 nolacp
switch#show aggregator 1
or
switch#show aggregator 2
or
switch#show aggregator 3
switch(config)#no aggreator lacp
1
group 2
Example
switch#vlan database
switch(vlan)#vlanmode portbase
or
switch(vlan)#vlanmode 802.1q
or
switch(vlan)#vlanmode gvrp
Switch(vlan)#no vlan
switch(vlan)#vlan port-based
grpname test grpid 2 port 2-4