KitchenAid KHWS160VWH5 Installation Instructions Manual page 7

NOTE: DoNOT plug power s upply cordintooutlet.
=Lay spout assembly on flat
surface with coiled tubing facing up.
Using one hand to hold tubingjust
below spout, carefully straighten
tubingwith other hand. Slide gasket
over tubingso that lip side of gasket
is seated into base of spout.
=Loosen square nut until it is
flush with end of the mountingscrew.
Tip spout bracket against mounting
screw. (Bracket will form a "y" when
in the correct position.)
Hold nut, bracket, gasket and tubing
in position and insert into hole in sink
or counter.
.Pull up on spout bodyto keep
tension on spout mountingbracket
and nut.Tighten screw inside the
spout until spout is securely in
position.Do not overUghten. Snap
on On/Off Cap.
=Positiontank verticallybeneath
spoutso that clear tubing from spout
reaches center stainlesstubing on
tank, and tank touches wall. Use a
pencil to mark on the wall where the
top of tank needs to be located. Set
tank aside. Mark a second line 2-1/4"
(5.7 cm) below the first line.
Positionmountingbracket on wall so
that bottom of mountingbracket is
even with the lower line. Use two
screws (and plastic anchors if
attachingto dry wall) to fasten
mounting bracketto wall. Hang tank
on bracket.