Standby, Scanning, Reverse, Monitor, And Dtmf; Standby (Dual Receive); Scanning - Wouxun KG-UV6D User Manual

Enter dealer password:
Select required channel to alter
Make required channel parameter changes
Restart to exit dealer mode:
"Standby" is used by Wouxun to refer to watching activity on both frequencies (dual receive) when in dual frequency or dual channel modes,
"Scanning" is an automatic frequency/channel change to detect busy frequencies, "Reverse" refers to receiving the transmit frequency of a repeater
input and "Monitoring" means to open the squelch temporarily to listen to a weak signal. How scanning behaves is dependent on the mode.

5.1 Standby (Dual Receive)

When in dual frequency or dual channel mode the master frequency is indicated with an ► arrow at left of the chosen frequency/channel. However,
the radio is also watching the secondary (sub) frequency. If the master frequency is clear signals detected on the sub frequency break through and an
S
is displayed in the upper right of the LCD display. If you do not require this dual receive behaviour switch to single frequency/channel mode with
S/D . In single frequency/channel mode KGUV6D is displayed in place of a second frequency or channel.

5.2 Scanning

Ensure frequency step is appropriate:
To scan in either VFO, Channel or FM Radio Mode:
To change scan direction:
To tune to a frequency or channel:
To set scan type:
TO = time out scan - continues scanning if no operations 5 seconds after receiving a signal
CO = carrier out scan - pauses when receiving signals and continues 3 seconds after no signal
SE = search scan - scanning stops when a signal is received
Note that these Wouxun radios do not have VFO mode scan limit edges.
2 6 8 1 6 0
MENU A/B MENU

5 Standby, Scanning, Reverse, Monitor, and DTMF

MENU 1 MENU ▲ (until correct step is selected), MENU EXIT
SCAN* (long press)
▲ or ▼
▲ or ▼ (long or short press, or ROTARY )
MENU ▼ to select TO/CO/SE scan type, MENU EXIT
MENU 1 9
10